The vent in the head (below the toilet roll dispenser). We should have vacuumed up our dust before taking the picture!

Bilge shot showing pump install location, the new strainer and if you look close to the left of the strainer, the hole we had to drill in the bottom of the boat. Not the favorite part and my installer did it when I was not there (I don't think he thought I could handle it!)

Location of the control unit. This is a air/heat/humidifier unit.

Well, that is it for now. I know a couple of guys here had asked to see what I was doing, so hopefully this helps. I would be happy to answer any questions too.
We have the boat fully wheeled out now, the air almost done and the trailer has been gone through completely too, so we are getting close to being ready!

Nice work! The A/C on mine is enough to freeze you out even on the hottest days, it's great!
Just wondering what the space is like behind the head compartment liner? I want to install a shower, do you have one? Where the factory one is installed looks like there would not be much clearance to the hull side. Thanks.

Nice job!

Needforspeed: Yes, I have a shower, but no sink. Wish PQ would have put a small one in. The space is pretty tight, but better than we anticipated. But, we dropped that run to 2" to give us as much room as possible.

NEED, there is probably a foot from the head liner to the hull side, if you pull off the toilet paper (4 screws) you'll be able to have a look inside......Put the plumbing in the same area as the toilet paper dispenser.

Looking like a lot of nice work going on!

Thanks for the info guys. I was going to borrow a borescope and look behind there before any cutting!

No need for the borescope, it isn't that tight in there, but a little mirror will help.