Originally Posted by Drock78

Im curious what you did there too Tom..Im trying to figure out something similar

Originally Posted by Drock78

Im curious what you did there too Tom..Im trying to figure out something similar

Originally Posted by boatnt

besides you can NOT place the baby in there while underway,,

Originally Posted by boatnt

Its a Fountain thing,,,you wouldn't understand,,,

Originally Posted by commandersander

Connections of wire to wire should be soldered, then sealed with plastidip tool dip.

Wire to connector (ring, spade, male-female butt) shoal be non insulated crimp then solder then platidip. Another is liquid tape....same stuff. The important part is lack of exposure to air and moisture.

Copper stranded is a recipe for disaster.

Everything I just wrote is related to dc. Dc travels on the outside of the strand......so more strands, lower resistance (impedance higher)

1 20a gfi will feed an additional 9 on the load side. Ac uses the entire line, so solid is a much better decision. Always ground up....or opposite of what u see in your house. This is for safety. Only.

Originally Posted by Knot 4 Me

According to an active thread in the Tech section, your outlets should be ground side up.

http://www.offshoreonly.com/forums/g...repower-5.html

Originally Posted by boatnt

Yeah I read that but he is also recommending solid wire and also soldering the wires as well which from what I have read is a big no no,from what I have been told solid wires and soldering wires on boat could crack,,,,thanks on the outlet tip I will look into to ,,I did it according to the instructions in the box

Originally Posted by Knot 4 Me

Not saying how you did it was wrong. I just wanted to point out a thread on the same topic showing the outlets upside down. First I had heard of that. I will be interested to see how Formula wires their outlets up when I am down in LOTO here in a few weeks.