What is the model number on your microwave?
 

I would like to get a microwave to fit in the hole where there used to be one. Was wondering what they came with.

Im sure they're discontinued but maybe i can get the spec's similar for a new one.

Thanks.

LOL, mine broke and trying to find a suitable replacement.....so far no luck. The original has a very short height.

I have the number but couldnt find any. I can post up later.

Was going to start a thread later and ask the same.

HELP US BOTH!!

Mine is a Vyper.

Thanks for the help, Keith! I think I'd use one quite a bit.

Fellas,

My original was a Sanyo EM-n107W.

Upon removal, I noticed they took the "feet" off the back edge, they were left on the front.

They "mounted" it by a mound of 4200 or equilivant. I had to use a saw on the top to cut through it.

Also, the fiberglass panel was cut out behind the microwave to allow more depth.

Just can't find one that low height.

A public thank you to anyone that leads to procurement of a new microwave is being offered!

Pretty sure my 1997 380 is a Samsung. I will be tinkering over the holiday weekend and will get you a PN.

My Avenger has a Gold Star brand for what it's worth.

From what it looks like by my little search time, any .6/.7 cu ft. microwave that was around 10" tall is discontinued.

The Sanyo model posted above dimensions are 18-3/16 w x 9-13/16 h x 13-13/16 d.

edit:

I found this with a little more digging this morning - http://www.bestbuy.com/site/emerson-...&skuId=8801093

17-1/8" w x 10-1/4" h x 12-9/10" d

Great Lakes Skipper has some Sylvania 0.6 cu/ft units with similar dimensions; although black not white...
Have you tried any R/V dealers?

Yeah, we just had to make the openings for the Micro's bigger on all the new Tiara's too.

The opening I don't think will accept 10 inches. My dad is retired, I'm sending him to measure some at stores. I've noticed that the advertised dimensions are not entirely accurate.

Also, as I mentioned, PQ remove the rear feet to lower even more.

No, I haven't.

The ones at skipper are 220, not 110. Also I think it is too high.

Sounds like a perfect job for a retired guy! ha.

I have an Emerson in my project office that meets the measurement requirements. I think I will keep it for a spare if the one in my boat goes bad.

Update. My Dad was over today to eat some turkey. We measured the old micro and next week he will start the search.

Stay tuned Venomous.

Sounds good. Hope he can find something that fits.

Was at home depot over the weekend and they have some small ones that will work...might want to go take a look..

boatnt - that one says 11.5" tall.


There's this one...

i keep finding ones that are slightly taller than 10" but haven't physically seen them so i don't know if there's feet that could be removed or what.

Still looking? Danby brand has one that is 10 2/16" tall...http://www.danby.com/en/US/our_produ...ng/dmw077blsdd

Found my microwave owners manual and its a goldstar MA-693M or MA-693MB by LG Electronics Inc.

Just replaced mine because it was a 500 watt unit that would not pop popcorn very well or heat up anything in a short amount of time. Went with a GE and love it it's 700 watt and works well. Burned my first bag of popcorn with it.

Model #: JES0736SPSS