Offshoreonly.com - Thrust Bushing needed for Cleaver Prop on TRS

Page 2 of 2

Show 40 post(s) from this thread on one page

Offshoreonly.com (https://www.offshoreonly.com/forums/)

- Prop Talk (https://www.offshoreonly.com/forums/prop-talk-165/)

- - Thrust Bushing needed for Cleaver Prop on TRS (https://www.offshoreonly.com/forums/prop-talk/104852-thrust-bushing-needed-cleaver-prop-trs.html)

cuda	07-02-2005 09:45 AM

Re: Thrust Bushing needed for Cleaver Prop on TRS

I run the same prop on my Minx without a thrust washer.

Poorsche

07-15-2005 10:36 PM

Re: Thrust Bushing needed for Cleaver Prop on TRS

I read the TRS Installation manul and it talks about a "continuity washer". I've looked around marina and asked "mechanics" and they don't even know what I'm talking about.

Does anyone on here know about the "continuity washer" ?

In fact the manual also shows a "continuit spring" on the trim cylinder shafts between the rubber bushings. Another "I dunno" from mechs. Dnyone else know about this little device?

All times are GMT -5. The time now is 11:25 PM.

Page 2 of 2

Show 40 post(s) from this thread on one page