Re: Throttle Up Raises the Bar
 

The rake angle is a little less on our props than a Maximus. Typically when you get into the higher pitch range boats usually don't need as much rake in the props. This is due to many factors including boat design.

The Maximus prop has a lot of cup in the tips of the blades. Keep in mind that Mercury needs to make a prop that out of the box will work on a wide variety of boats. Hence their props have to be made so they will fit a wide range of applications. Mercury sells the same props to boat manufacturers and their props need to work on all of them.

Matt

Re: Throttle Up Raises the Bar
 

Julie,

Congratulations on your new product line. The best just keeps getting better!!!!


Thanks,
Dail Bennett

Re: Throttle Up Raises the Bar
 

Thank you all, for the inquiries and positive support this week!

Julie & Matt &
The Staff of Throttle Up Propellers

Re: Throttle Up Raises the Bar
 

As I have always said, you guys are the best.

Vinny

:drink: :drink:

Re: Throttle Up Raises the Bar
 

Before Throttle-Up came out with the CNC props, every set of props we ordered was a gamble.....and every prop had to be tweaked.

Now, with CNC machining and finishing you are guaranteed that left hand prop will be exactly like the right hand prop. You can also be assured that if you need to replace a prop, the new prop will be an exact duplicate of the previous one.

No more guessing, no more time and money wasted on testing and tweaking.....you get the exact same prop every time.

70% of the time we put on the race boat has been testing...and 80% of that time was for checking and tweaking props. With the CNC props, once you have your setup...your done.

Com'on oyster beds, sand bars, and underwater monsters...eat my props. I can get another set exactly like these.

Ken Doyle
Mid-American Offshore
SBI/APBA Super V #10

Re: Throttle Up Raises the Bar
 

The most important benefit..............they are FASTEST Props we have ever run!

Re: Throttle Up Raises the Bar
 

Thanks Ken. We will spend the day today at the 10th street boat ramp in Sarasota testing, testing, testing. We will be testing on several race and pleasure boats further validating the performance of our CNC props.

Looking forward to finalizing the dialing in on your boat, Ken.

Matt

Re: Throttle Up Raises the Bar
 

Our CNC props are available in either a polish finish. Or a machine finish.

Re: Throttle Up Raises the Bar
 

How Many Different Shafts Will Be Available ? I Run A 19 Spline Speedmaster Longshaft. Run A 16x32 4blade At 6000 Rpm Always The Slip On The 4 Blade Is 13% And My 3 Blade Is 18%. More Blades Less Slip

Re: Throttle Up Raises the Bar
 

I had no problem, it was just a tongue-in-cheek comment but I admit, I was also was thinking at the time about how pricing being discussed in forums by vendors was generaly prohibited (hence why I assumed the comment was made to Sea-Dated) and didn't think about the fact that I'd never seen that with OSO.

My bad. I'll sit down and go back to my drink now. :drink: