42 fountain prop help
#1
Registered
Thread Starter
Join Date: Jul 2008
Posts: 225
Likes: 0
Received 0 Likes
on
0 Posts
42 fountain prop help
Boat runs great with 32 pitch 4 blades. Tough to get on plane, but decent overall. Tried a stock set of maximus 30 pitch, hoping to get on plane better, and have better midrange. Results are not what I expected. Almost impossible to get on plane. The boat keeps blowing out anywhere over 3000 rpm. Under 3000 rpm it does not want to pick up speed to plane off. Have tried tabs in all positions, drives are tucked. Usually 4 people, and 100 of fuel on board. 2004, 525 boat.
#2
Offshoreonly Advertiser
Offshoreonly Advertiser
Strange. Do you have any history on the props?
Have they been repaired or worked?
Brtt
Have they been repaired or worked?
Brtt
__________________
Brett Anderson / BBLADES Professional Propellers
920-295-4435 http://www.bblades.com/
[email protected]
Brett Anderson / BBLADES Professional Propellers
920-295-4435 http://www.bblades.com/
[email protected]
#3
Registered
Thread Starter
Join Date: Jul 2008
Posts: 225
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for chiming in Brett. Stock maximus 5 blade 30's. full diameter. No repairs or work I'm aware of. I switched back to 4 blades just to make sure I didn't have other issues. They were fine. It was a 1/2 mile balancing act to get the boat on plane with the maximus props. Could my drive showers be to close causing cavitation or something? Just thinking out loud.
#4
Getting more blowout from the maximus props over the bravo 1's seems strange for sure. It would almost seem like you need higher pitch but it totally makes sense to go from 32 Bravo's to 30 Maximus..
What drives / lowers are on your 525's? Is it a full stagger? If they are short sportmasters, you might have to remove the splash plates using full diameter maximus props. I've had good results with the max's. Went from 6-blade Herings to max's and got less blowout.
What drives / lowers are on your 525's? Is it a full stagger? If they are short sportmasters, you might have to remove the splash plates using full diameter maximus props. I've had good results with the max's. Went from 6-blade Herings to max's and got less blowout.
#6
That is very strange. Are you 100% certain that the max props you have are box stock? I recently bought two maximus props from someone who told me the "only" thing they did was take them down to 15 1/2 diameter. I ran those props and got terrible results. I then ran the out-of-the-box stock maximus props there was a 10 mph difference and planing and handling was totally different and I thought the "only" difference was 1/8" diameter. No complaint about the seller I bought the props from because they disclosed that previously, but I couldn't believe there would be such a difference and there was. If you're certain they are stock, then I'm stumped. You might try removing the water pickup from the drive shower to see if that makes a difference but put a cap bolt in there with a nut on top of the cavitation plate so you don't leave a hole in the plate.
#7
Offshoreonly Advertiser
Offshoreonly Advertiser
I agree with HyFive that it seems there might be some "repair work done to the Max props.
Also, I don't like to install drive shower pick ups more than 1/2" below the cav plates. I'll go shorter if possible. They can cause a cavitation bubble that can disrupt the high pressure on the face of a propeller blade upon planning or once under way.
Brett
Also, I don't like to install drive shower pick ups more than 1/2" below the cav plates. I'll go shorter if possible. They can cause a cavitation bubble that can disrupt the high pressure on the face of a propeller blade upon planning or once under way.
Brett
__________________
Brett Anderson / BBLADES Professional Propellers
920-295-4435 http://www.bblades.com/
[email protected]
Brett Anderson / BBLADES Professional Propellers
920-295-4435 http://www.bblades.com/
[email protected]
#10
VIP Member
VIP Member
Join Date: May 2002
Location: Central Illinois
Posts: 1,096
Likes: 0
Received 0 Likes
on
0 Posts
I'm running 30 maxs on my 04 with 525. Drives are sport master shorties with 1 inch spacers. Had to put them in because stock maxs would hit cavitation plate. Had BBlades cut and rework them to work without spacers. Boat runs stronger and has more mid range acceleration than before.
Next is to take spacers off and try that. Planes great with the 30s, much better than the bravo 32s.
Next is to take spacers off and try that. Planes great with the 30s, much better than the bravo 32s.