Help with prop to Chris Craft 260 Stinger
#91
Registered
Thread Starter
#94
Registered
Thread Starter
And with your description that if the upper is a X the upper decides what the gear ratio it will be?
So the only thing that can affect a prop change is the height of the prop shaft after I install the XR lower.
#96
Registered
Thread Starter
I dont know if it was leaking or if it was reversion.. Switched to EMI Thunder pipes.
But now I have problems with my drive instead.. gears are stuck in forward. Cant switch to neutral or reverse..
I hope the XR lower will help me
#97
Registered
Thread Starter
I got the XR lower at home now waiting for installation. Prop shaft will be +2” lower with this, it getting me to like 3,7” below bottom.
Just dealing with another problem right now. My upper is stuck in forward gear, hope its just the clutch that is stuck in lower gear and it is just to press it out. Have another thread about this. So my upper is apart right now.
Just dealing with another problem right now. My upper is stuck in forward gear, hope its just the clutch that is stuck in lower gear and it is just to press it out. Have another thread about this. So my upper is apart right now.
#99
Registered
#100
Registered
Thread Starter