Apache Warrior Props
10-09-2020, 08:09 AM
#1
Gold Member
Gold MemberThread Starter
Apache Warrior Props
I am putting together a 36 Apache Warrior with SSM 3A's prop shafts are 4" below the running surface. Power will be around 600hp per side and looking for a good starting point for props.
as expensive as these things are I'm hoping we get pretty close on the first try...suggestions?
as expensive as these things are I'm hoping we get pretty close on the first try...suggestions?
10-09-2020, 12:59 PM
#2
Joe, the boat had 17x28 4 blade props with the motors that were in it . Approximately 850 hp. Spinning to about 5800. It depends on what rpm your motors make power . Not knowing your motor specs I would say 17x 26 should get you close . Tom
01-10-2021, 11:55 PM
#3
Platinum Member
Platinum Member
iTrader: (3)
Join Date: Jan 2007
Location: Jackson, n.j. ~ Brooklyn, n.y.
Posts: 2,083
Received 151 Likes
on
77 Posts
I hope Joe found the right props to help set up his Apache,....I on the other hand have a 35 Cig spinning (2) 18x26 - 3 blades off SSM #3's 650 hp. @ 5500.
Boat was rigged in the mid 90's and runs super flat & quick out of the hole...Owners of Flagship Marine knew what they were doing back then, but I always
thought what a 4 blade would do to current performance...seems not many back then used a 4 blade...am I wrong?.
Boat was rigged in the mid 90's and runs super flat & quick out of the hole...Owners of Flagship Marine knew what they were doing back then, but I always
thought what a 4 blade would do to current performance...seems not many back then used a 4 blade...am I wrong?.
