|
No problem. Ill be by
|
Been lazy....
2 Attachment(s)
Here I go again.....
So the tape on the bottom of the template can be removed, and more plastic filler (bondo) can be pushed into the other side. No worries about the Lowrance.....It still has the tape on it.... |
5 Attachment(s)
Once it dries, I use a razor around the back side to help me release the Lowrance.....then push it out. The mess is gone when I take the tape off....
Then I grind the extra off of the template and trim the opening with a straight cut bit in the table..... |
2 Attachment(s)
Perfect.
The Lowrance now has a template that is a 100% accurate negative of the hole it needs to live in....and the profile is very low too! |
3 Attachment(s)
Tape it up (dbl stick) and position it onto the panel where you want the Lowrance....
Drill the corners....cut....done.... |
3 Attachment(s)
Check that fit!
|
Back on top for easy find
|
| All times are GMT -5. The time now is 09:22 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.