its nearly impossible to get a side shot, have all the finish work done on the capping. Going to gelcoat that next to really tune up the line. I like the clean look of capping and this thing was nearly capped from the factory. The deck and hull joint are as about as close as you could want to do this process.

seriously . . . . . who builds a floor THIS thick . . . . (piece taken out for rocket launchers . . . . er . . . rigging tubes)

Crazy Dave... you must have forgotten where this boat came from... the pole was in the middle of the " COCKPIT" and I use that term with total hilarity!!!

ahhh . . . yes . . . that does make sense now . . . . lol

so... dust has started !!!

Nice project!

oh we been making dust all along. . . . . its just that the piles are getting bigger now

I just found this thread. I gotta pay better attention. Looking good Dr. Dave.

from the pic it looks like, balsa --- 20 layers of glass--- balsa
if it is glass in between, why in between and why so many layers for a floor ?

if the dust gets any deeper on the shop floor you'll have to bust out the snowblower
when i look at that picture i start itching, it's like sympathy vomiting or a contact high you get a rush concert.

lol yeah Dan the glass dust doesnt even bother me anymore . . . .

yes the floor is balsa . . . kevlar . . . about a dozen layers of glass . . . etc