Got my electronic trim tab indicators wired up last night and wired in, sensors take a 12v source , and output a 5v signal to AEM 22 channel Can sensor module to CAN so it can be sent to my AEM cd7 Dash. Not to bad to configure and pretty neat once set up. I have two wires going to the front of the boat for all signals instead of one per signal.

Great build!

What is the part number of the trim sensors? Where did you get them? I was going to run some linear potentiometers off the cables into a 3D printed box. Your appear much easier.

Beautiful build, very clean & done neatly. Just a question, the Hardin Marine exhaust flaps, are they spring loaded or do the rest closed naturally?

I picked up these from hardin marine, not cheap but the cleanest option I could find, no way I was running cables to the cockpit from each tab .

https://www.hardin-marine.com/p-8023...kit-gen-1.aspx

They rest closed naturally

New Prop came in MAX5 27P, IMCO SC drive should be here on Tuesday.

IMCO SC drive showed up today.

Do you think that prop is going to be big enough for that engine? Or are you going for better holeshot? I know nothing of imco drives so that could have something to do with it. Just curious.

I think it will be a good starting point, The person running it before was running the prop with a slightly larger boat and ~800hp so I figured mine with ~750 on a smaller boat would match up, wont know until spring though. Wrapping up for the season and getting the boat ready for storage.