|
Originally Posted by Unlimited jd
(Post 4818914)
Several top guns had 6’s on boxes. I had an album stored in one of my old phones of all the ssm 6 guns.
Which leads me to my second question. I got dry sump inner transom assemblies with these so no resevoir. At what height should I mount the overflow? Any idea? Aslo what oil in the driveline gimbal? |
yes, fill it from the bottom through the drive, right into the tank
The wet sumps used a tank built into the inner transom plate. You can mount a tank so the level of the oil stays in between the top and second bolt hole in the transom. Gear oil in the drive line carrier, same oil you decide to use in the drives. Torco, amsoil, newer merc gold. |
So excited for you it's going to be badass and with the entire new setup you will break 100 easy! So badass
|
I think I got it figured out , I got some laser high tech $hit going on over here that helped lol
23* fun times . https://cimg7.ibsrv.net/gimg/www.off...ce8bd25758.jpg https://cimg9.ibsrv.net/gimg/www.off...7c070e3a53.jpg https://cimg0.ibsrv.net/gimg/www.off...a4948f6c3a.jpg https://cimg3.ibsrv.net/gimg/www.off...718dfa8724.jpg https://cimg4.ibsrv.net/gimg/www.off...44cbd82f8f.jpg |
BRrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrr
|
Had to think about those pictures for a minute, it looks like the whole assembly was leaning up against the transom and supported by the floorjack on the propshaft, raised up/down tapped around and marked, then i realized you had that custom template to find plumb, center and X, the floorjack was just holding nuetral trim for the laser double check and pics.
nice job, hell of an update ! you take a picture with the template ? |
No trim hooked up so yes you have it right.
The templates are pretty sweet , I`ll snap a picture of the set up later . |
Hey Dan if you want wet sump six inner plates with the reservoir, I have a set. I will trade u for the dry sump plates. I have a set of wet sump sixes that were converted to dry sumps that I will be selling . I would rather have dry sump plates. Tom
|
Originally Posted by TomFTM
(Post 4819055)
Hey Dan if you want wet sump six inner plates with the reservoir, I have a set. I will trade u for the dry sump plates. I have a set of wet sump sixes that were converted to dry sumps that I will be selling . I would rather have dry sump plates. Tom
I was going to use my latham bottles but I`d be up for that . clean up the transom a bit . shoot me an email [email protected] |
Originally Posted by ICDEDPPL
(Post 4819079)
I was going to use my latham bottles but I`d be up for that . clean up the transom a bit .
shoot me an email [email protected] sent. |
| All times are GMT -5. The time now is 07:06 AM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.