My Scarab Viper
#13
running ... the boat hanging tough on the right of the video is a 94 mph Scarab Panther owned by Forum member Blue Thunder ... We were pace boats for a local poker run ... you can hear and see when it was time to go .
Last edited by 737jetmech; 04-05-2013 at 10:12 PM.
#15
@050
19.0 BTDC open 57.0 ABDC close 109 max 256 Duration
71.0 BBDC 13.0 ATDC 119 264
Intake 318 Degrees Exhaust 326 632 @ valve intake / exhaust . installed @ 107
Didn't see any gain in power on the dyno ...
#16
Gold Member
Gold Member
Scarab
Great looking boat. What an amazing project. Next year we'll put some HP's to ours as well. Have a great season !!!
#18
Registered
iTrader: (4)
3.34 pulley ... 731 works really well ... last year I upgraded to a custom Teague blower cam ... it's used in the 800 SC ... grind fall's between the 741 and the 651 similar to Cranes 139661 grind
@050
19.0 BTDC open 57.0 ABDC close 109 max 256 Duration
71.0 BBDC 13.0 ATDC 119 264
Intake 318 Degrees Exhaust 326 632 @ valve intake / exhaust . installed @ 107
Didn't see any gain in power on the dyno ...
@050
19.0 BTDC open 57.0 ABDC close 109 max 256 Duration
71.0 BBDC 13.0 ATDC 119 264
Intake 318 Degrees Exhaust 326 632 @ valve intake / exhaust . installed @ 107
Didn't see any gain in power on the dyno ...
That's to bad no gain. I have the same pulleys on my 250's and finalizing some custom cams this week. Probably run NA for the first half of the season then put the blowers on my 454's. What was your compression ratio if you don't mind me asking?
#19
Registered
Join Date: Sep 2009
Location: perrysburg, oh
Posts: 204
Likes: 0
Received 0 Likes
on
0 Posts
that thing sounds awesome man!! sick scarab! great job!
#20
I have a new pair of 3 inch pulleys ... no plans to use them being @ the edge of a 93 octane tune already .
Last edited by 737jetmech; 04-08-2013 at 07:32 AM.