My Scarab Viper
#34
Registered
Join Date: Aug 2012
Location: Greenbrier , Arkansas
Posts: 571
Likes: 0
Received 0 Likes
on
0 Posts
#36
Registered
Join Date: Nov 2001
Location: Pennsylvania
Posts: 3,385
Likes: 0
Received 0 Likes
on
0 Posts
Probably my last legitimate jab at Jetmech. If he can get on plane with the shorties he'll be going past me like I'm standing still. Great work as always Bob!
#38
Bob do you have any problem with the duel tie bars binding up, was going to do the same set up, but read on here about if the tie bars are not on the same pivot center they could bind up. also I see you your using the Imco plates at the back of the drive, I have a set of those for my Xr sportmasters, but when I mount them I still have that hole underneath the plate were the zinc would mount, i'm I missing a piece to cover that hole, or you just use it with that hole open like that, my thought it would slow you down with the water going up in there.... By the way they look great on there, hope they work out for you, Thunder told me he picked up 12mph when he raised X dimension on his scarab, even if you get half of that, it should put you in triple numbers
#39
Registered
Join Date: Nov 2001
Location: Pennsylvania
Posts: 3,385
Likes: 0
Received 0 Likes
on
0 Posts
Bob do you have any problem with the duel tie bars binding up, was going to do the same set up, but read on here about if the tie bars are not on the same pivot center they could bind up. also I see you your using the Imco plates at the back of the drive, I have a set of those for my Xr sportmasters, but when I mount them I still have that hole underneath the plate were the zinc would mount, i'm I missing a piece to cover that hole, or you just use it with that hole open like that, my thought it would slow you down with the water going up in there.... By the way they look great on there, hope they work out for you, Thunder told me he picked up 12mph when he raised X dimension on his scarab, even if you get half of that, it should put you in triple numbers
#40
Yeah Joe ... 12 mph would be nice ! I'll be happy with 4 or 5 ... drives were set @ 6 inches ... the real test is getting on plane ... this boat has always had a little trouble ... 3 blades... ha ha ... forget it ! 4 blade bravos ... ok with some blow out just as it rolls over then hooks up 200 -300 feet later . That why I went with the p5x hydros ... had good results with them on my Nova ... with better speed numbers than the bravo's .
Here is a picture of the plates Imco provided to cover the open area @ the rear of the gear case . Sportmaster may be a little different ?
Never had an issue with the dual tie bars ... as long as there adjusted the same ...they should not bind .
Here is a picture of the plates Imco provided to cover the open area @ the rear of the gear case . Sportmaster may be a little different ?
Never had an issue with the dual tie bars ... as long as there adjusted the same ...they should not bind .
Last edited by 737jetmech; 05-13-2013 at 07:43 AM.