Offshoreonly.com - Search Results

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: Waverunnering
Showing results 1 to 19 of 19
Search took 0.00 seconds.
Forum: General Q & A
05-11-2013, 09:45 AM
Replies: 5
Views: 625
Posted By Waverunnering

Someone has to know something about these motors...

Someone has to know something about these motors I hope!!
Forum: General Q & A
05-08-2013, 12:13 PM
Replies: 5
Views: 1,299
Posted By Waverunnering

I found with my formula I had two separate...

I found with my formula I had two separate problems when I had a similar problem. I ended up pulling the trim sensors apart and found some corrosion inside of them. Cleaning the contacts adding some...
Forum: General Q & A
05-08-2013, 11:50 AM
Replies: 5
Views: 625
Posted By Waverunnering

320EFI timing mode. HELP!

I have twin 320's in my Formula 272 and one just seems to be running a little flat. Before I go accusing my cam I would like to put it into timing mode to check that. I had a Baja 272 with a 502 that...
Forum: Formula
05-05-2013, 10:59 AM
Replies: 10
Views: 3,439
Posted By Waverunnering

Motors already have a set of EMI manifolds on...

Motors already have a set of EMI manifolds on them and with looking to go the LS route down the road I will be saving pennies for that. My biggest issue with the 320's is finding someone that knows...
Forum: Formula
05-03-2013, 10:12 PM
Replies: 10
Views: 3,439
Posted By Waverunnering

Yeah the spacing is what I was worried about. The...

Yeah the spacing is what I was worried about. The 320's are doing alright... One is running a little flat but this is only my second season with the boat. Last year was only able to best 60 spinning...
Forum: Formula
05-03-2013, 01:55 PM
Replies: 10
Views: 3,439
Posted By Waverunnering

Swapping SB's for BB's in a 272

So I am hoping I can get some good answers on here. I have what many have told me is a very rare set up in my '88 272 SR1. Currently running twin 320EFI's on Bravo 1 drives. (anyone else have a pair...
Forum: General Q & A
06-09-2010, 06:19 PM
Replies: 13
Views: 2,529
Posted By Waverunnering

What size motor?

What size motor?
Forum: General Q & A
06-09-2010, 06:17 PM
Replies: 13
Views: 9,855
Posted By Waverunnering

Wouldn't even consider going 383. Your going to...

Wouldn't even consider going 383. Your going to be very disappointed running a small block. They may be easy to get the HP out of a 383 but your not going to get the torque you need.
06-09-2010, 11:10 AM
Replies: 6
Views: 2,289
Posted By Waverunnering

Banks Marine Concept Twin-Turbo Duramax Diesel V-8

Thought I would get a forum going regarding the twin turbo concept Banks is working on.( http://www.banksmarine.com/ ) Is there anyone out there with some inside info or seen on in a boat yet?...
Forum: Northeast US
06-03-2010, 01:30 PM
Replies: 7
Views: 810
Posted By Waverunnering

Resturaunts on the hudson between newburgh and tapen zee

I have tried to search and search but can not find answers. I am trying to figure out all of the dining options south of the newburgh beacon bridge. I know of all of them from the newburgh water...
05-18-2010, 09:36 AM
Replies: 4
Views: 1,235
Posted By Waverunnering

XR lower Stock bravo on top.

This may have been discussed before but i can not find it in a search. Is it worth it to put an XR lower unit on a factory bravo 1 drive. I know obviously you are gaining the larger prop shaft. Am I...
Forum: General Q & A
04-21-2010, 06:37 PM
Replies: 7
Views: 977
Posted By Waverunnering

This is being tested with a load tester hooked to...

This is being tested with a load tester hooked to the battery that also checks the charging system. everything is tight so I am most likely going to just buy an alternator and if it doesn't change...
Forum: General Q & A
04-20-2010, 08:10 AM
Replies: 7
Views: 977
Posted By Waverunnering

Charging question

So I am trying to determine if my alternator is on it's way out. Now every other boat I have had it needs a little throttle to excite the alternator and it will charge at an idle. My current boat is...
Forum: Baja
04-06-2010, 09:47 AM
Replies: 1
Views: 725
Posted By Waverunnering

Unhappy Lokking for back of bolster seat.. any help appreciated!!!

So with all the wonderful news of most of Baja parts being bought by sea ray you can all imagine how hard it is to track down parts...

So here is what I am looking for so if anyone knows some one...
Forum: Baja
03-29-2010, 06:36 AM
Replies: 2
Views: 833
Posted By Waverunnering

Yeah I was really hoping not to hear that answer....

Yeah I was really hoping not to hear that answer. Think I am just going to have different color seat backs for now.
Forum: Baja
03-27-2010, 10:15 AM
Replies: 2
Views: 833
Posted By Waverunnering

Taking apart bolsters???

I have a 2000 272 with the aero bolsters. On side has yellowed beyond noticeable and I am trying to figure out how to take them apart to paint it.Can't find screws or bolts anywhere! I am sure hoping...
Forum: General Q & A
02-07-2010, 09:02 AM
Replies: 8
Views: 1,023
Posted By Waverunnering

The numbers are from a cold engine

The numbers are from a cold engine
Forum: General Q & A
02-06-2010, 06:44 PM
Replies: 8
Views: 1,023
Posted By Waverunnering

Thanks for the replys. I appreciate your help

Thanks for the replys. I appreciate your help
Forum: General Q & A
02-05-2010, 06:55 AM
Replies: 8
Views: 1,023
Posted By Waverunnering

Opinion on compression results for 502

How is it going new to this forum and looking for some helpful opinions. I am looking at a 2000 Baja 272 with a 502 in it with 400 hours on the motor. I just had a compression test ran on the motor...
Showing results 1 to 19 of 19


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.