Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: 87MagnumII
Showing results 1 to 25 of 500
Search took 0.03 seconds.
Forum: Drives and Lower Units
08-20-2024, 08:49 AM
Replies: 3
Views: 792
Posted By 87MagnumII

It had unfortunately just been serviced and I...

It had unfortunately just been serviced and I don’t think they filled it correctly. I had already drained it in that picture but the reservoir was low to the point of being empty. I should have...
Forum: Drives and Lower Units
08-19-2024, 10:41 PM
Replies: 3
Views: 792
Posted By 87MagnumII

https://cimg8.ibsrv.net/gimg/www.offshoreonly.com-...

https://cimg8.ibsrv.net/gimg/www.offshoreonly.com-vbulletin/1125x1628/img_8296_1d05c24d9e28225bec02fea6fbd54a4b4313630d.jpeg
Forum: Drives and Lower Units
08-19-2024, 10:39 PM
Replies: 3
Views: 792
Posted By 87MagnumII

Oops, it got hot.

Got it a little hot.
Forum: General Boating Discussion
08-12-2021, 12:12 AM
Replies: 51
Views: 9,917
Posted By 87MagnumII

I absolutely smoked two uppers on my alpha drive...

I absolutely smoked two uppers on my alpha drive with a built 350. 20’ boat and **** ton of initial timing. Made a nasty noise both times lol
Forum: General Boating Discussion
07-30-2021, 07:54 PM
Replies: 43
Views: 9,281
Posted By 87MagnumII

Lake Cumberland. I love that fact that it’s very...

Lake Cumberland. I love that fact that it’s very rural and secluded.
Forum: Drives and Lower Units
07-26-2021, 06:28 PM
Replies: 2
Views: 2,317
Posted By 87MagnumII

Alpha One Gen 2 1.47 vs 1.50

My boat is a 1994 model and came with a 350 MAG and Alpha One Gen 2. I know Merc used 1.47 and 1.50 ratios at some point but I’m not sure which I have as the case isn’t stamped. Anyone know if my era...
Forum: General Q & A
06-13-2021, 09:22 PM
Replies: 13
Views: 3,606
Posted By 87MagnumII

Update

Unhooked the shift interrupt switch and jumpered the harness side with a wire. Boat runs like a top but I’d obviously difficult to shift with the interrupter disabled. Ordering a switch in the morning
Forum: General Q & A
06-10-2021, 06:42 PM
Replies: 13
Views: 3,606
Posted By 87MagnumII

I found this one on eBay for about $400

I found this one on eBay for about $400
Forum: General Q & A
06-10-2021, 05:52 PM
Replies: 13
Views: 3,606
Posted By 87MagnumII

Update: swapped the oil pressure switch and the...

Update: swapped the oil pressure switch and the low oil pressure code has gone away. It says no codes present on scan tool but the scanner also says the check engine light is on and it shows fault...
Forum: General Q & A
06-06-2021, 08:25 PM
Replies: 13
Views: 3,606
Posted By 87MagnumII

I haven’t replaced the oil senders yet. I’m...

I haven’t replaced the oil senders yet. I’m leaning on one of them being bad or having bad connection and it’s shutting down the fuel when it intermittently glitches
Forum: General Q & A
06-06-2021, 04:34 PM
Replies: 13
Views: 3,606
Posted By 87MagnumII

https://cimg2.ibsrv.net/gimg/www.offshoreonly.com-...

https://cimg2.ibsrv.net/gimg/www.offshoreonly.com-vbulletin/1125x1753/77f4b3d0_a9e4_455f_860b_f8a26742e324_c3f9769b6af1ef9925c74f8e20ea814ac97f09bf.jpeg
Also showing a low oil pressure indicator...
Forum: General Q & A
06-06-2021, 04:32 PM
Replies: 13
Views: 3,606
Posted By 87MagnumII

https://cimg9.ibsrv.net/gimg/www.offshoreonly.com-...

https://cimg9.ibsrv.net/gimg/www.offshoreonly.com-vbulletin/2000x1504/fd516cad_6fec_4079_bf54_1425b7f38d6f_2303f620ad17e8803a8e19d934985246bd339538.jpeg
Forum: General Q & A
06-06-2021, 04:32 PM
Replies: 13
Views: 3,606
Posted By 87MagnumII

350 MAG MPI stumbling. Need some help

I bought a used 350 MAG MPI last year and it’s had a gremlin since I’ve had it. Below is a little bit of a back story. Any help is appreciated.

Long story short, I bought the engine used last...
Forum: General Q & A
10-18-2020, 10:16 PM
Replies: 3
Views: 976
Posted By 87MagnumII

serial is 0L316222 (I believe it’s a 1998 model) ...

serial is 0L316222 (I believe it’s a 1998 model)
I bought it used, it’s a take out from a boat that came off the trailer. It’s stock as far as I know but does appear to have maybe had a refresh...
Forum: General Q & A
10-18-2020, 06:56 PM
Replies: 3
Views: 976
Posted By 87MagnumII

350 MAG MPI runs, for the most part. Need a little help

Got my new to me 350 MAG MPI in and running. It fires up and idles great, but it has a hesitation/bog when you lay the hammer down to get on plane. If you ease into it, it will go. It also has a...
Forum: General Q & A
10-18-2020, 06:50 PM
Replies: 7
Views: 5,104
Posted By 87MagnumII

gained 5mph loaded and it’s banging on the rev...

gained 5mph loaded and it’s banging on the rev limiter. It’s gonna need more prop for sure
Forum: General Q & A
10-17-2020, 08:47 PM
Replies: 7
Views: 5,104
Posted By 87MagnumII

Merc horsepower ratings

Where does Merc measure the HP on the MAG MPI engines? At the flywheel or prop shaft? I can’t seem to find a straight answer. I just swapped out a 350 MAG Carb engine for a 350 MAG MPI and I’m trying...
Forum: Drives and Lower Units
10-14-2020, 07:51 PM
Replies: 23
Views: 17,676
Posted By 87MagnumII

Friend of mine has one on a Concord Mach II with...

Friend of mine has one on a Concord Mach II with a 350 MAG MPI and it’s an absolute blast to drive. If I remember right his seems to like more of a neutral trim setting vs flying the nose a little...
Forum: General Q & A
10-13-2020, 09:48 PM
Replies: 1
Views: 1,458
Posted By 87MagnumII

Will this scan tool work?

Going to buy a scan tool my boat. Has a 1998 350 Mag MPI. My buddy has a 1997 350 MAG MPI gen+. Will this tool work for both of us?
...
Forum: General Q & A
10-10-2020, 10:43 PM
Replies: 7
Views: 2,630
Posted By 87MagnumII

Stainless marine exhaust pipe plugs

Best place to get the plugs needed to replace one of these elbows
...
Forum: General Q & A
10-07-2020, 03:40 PM
Replies: 3
Views: 1,037
Posted By 87MagnumII

thanks. The serial numbers say the bottom is a...

thanks. The serial numbers say the bottom is a 1997 and the top is a 1998 or newer. Why does the older one seem to have a single plane style intake on it?
Forum: General Q & A
10-07-2020, 03:07 PM
Replies: 3
Views: 1,037
Posted By 87MagnumII

What is the difference in these two engines?

https://cimg8.ibsrv.net/gimg/www.offshoreonly.com-vbulletin/920x2000/7ed5fb55_4394_432f_b25d_22922fee778f_9bb37be9ae073d39632332abfd82acf136257aaa.png...
Forum: General Q & A
09-30-2020, 09:41 AM
Replies: 3
Views: 742
Posted By 87MagnumII

im swapping the entire engine

im swapping the entire engine
Forum: General Q & A
09-29-2020, 10:42 PM
Replies: 3
Views: 742
Posted By 87MagnumII

350 MAG Carb to 350 MAG MPI

My boat is a 1994 model with a 350 MAG carb engine. I just purchased a 2000 model 350 MAG MPI to put in it. Will my boat harness plug and play with the newer engine or will I need to modify anything?
Forum: General Q & A
05-28-2020, 11:13 PM
Replies: 15
Views: 3,824
Posted By 87MagnumII

Problem Solved ...

Problem Solved

https://cimg5.ibsrv.net/gimg/www.offshoreonly.com-vbulletin/2000x1504/8dc4078b_46a6_4a85_a5f1_d59d4381a0a8_ce63cdf780384661ab9aa9e5b67040b122765934.jpeg
Showing results 1 to 25 of 500
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.