Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 3
1
2
3
Search: Posts Made By: MikeSXT25
Showing results 1 to 25 of 59
Search took 0.02 seconds.
Forum: Swap Shop
03-09-2024, 10:53 AM
Replies: 14
Views: 3,105
Posted By MikeSXT25

Had to remove risers spacers to clear engine...

Had to remove risers spacers to clear engine cover on my boat. They will come with it. Was pulled out of boat running. Is a DTS engine has all wire harness and throttle/shift quadrant that is...
Forum: Swap Shop
03-09-2024, 12:54 AM
Replies: 14
Views: 3,105
Posted By MikeSXT25

still available due to dead beat buyer...

still available due to dead beat buyer...
Forum: Swap Shop
09-07-2023, 12:33 AM
Replies: 24
Views: 8,666
Posted By MikeSXT25

5096798546 txt or call

5096798546 txt or call
Forum: Swap Shop
03-25-2023, 12:59 AM
Replies: 14
Views: 3,105
Posted By MikeSXT25

yes still available 3/24/23

yes still available 3/24/23
Forum: Swap Shop
01-12-2023, 11:28 PM
Replies: 14
Views: 3,105
Posted By MikeSXT25

yes sorry it is still available

yes sorry it is still available
Forum: Fountain
08-22-2022, 05:54 PM
Replies: 0
Views: 763
Posted By MikeSXT25

27 Fever parts needed

Looking for a Bimini for the wife and kid. Also needing drive indicator parts (cable, drive parts, dash indicator) good canvas cockpit and or full cover
Forum: Swap Shop
08-22-2022, 05:47 PM
Replies: 14
Views: 3,105
Posted By MikeSXT25

496mag ho

Complete 496 mag Ho DTS. 200hrs

https://cimg1.ibsrv.net/gimg/www.offshoreonly.com-vbulletin/2000x1504/09a0ef11_b2f1_4824_b566_854360691a6a_1961a332bd82b8d4a01d4db795da03a6ca6dac5a.jpeg...
Forum: General Q & A
06-15-2022, 01:40 AM
Replies: 8
Views: 1,064
Posted By MikeSXT25

Sorry been dealing with fam stuff. Engine...

Sorry been dealing with fam stuff.
Engine completely stock
-water temp 140-150. Thermostated
-timing 34 deg full advance with wire grounded
​​​​​​—pretty much always in 260-270 oil my temp range...
Forum: General Q & A
05-31-2022, 09:23 PM
Replies: 8
Views: 1,064
Posted By MikeSXT25

Oil temp issue

My 500hp carb motor in my new fountain. Is running just over 260deg on gauge. Temp sender is in block just above filter pad. I back flushed cooler (haven’t visually looked silent choice exhaust in...
Forum: Swap Shop
04-26-2022, 10:43 AM
Replies: 24
Views: 8,666
Posted By MikeSXT25

I replied. And yes engine still available

I replied. And yes engine still available
Forum: Swap Shop
03-30-2022, 09:59 AM
Replies: 24
Views: 8,666
Posted By MikeSXT25

yes. Motor is still available

yes. Motor is still available
Forum: Swap Shop
02-25-2022, 02:48 PM
Replies: 24
Views: 8,666
Posted By MikeSXT25

I’ll fix the inbox issue. I don’t want to sell...

I’ll fix the inbox issue. I don’t want to sell exhaust unless someone buys the engine without it first.
Forum: Swap Shop
02-25-2022, 02:46 PM
Replies: 24
Views: 8,666
Posted By MikeSXT25

Yes The parentheses are indicating the cost of...

Yes The parentheses are indicating the cost of those items alone. I forgot to put the price on it for the first 10 minutes and realized what I had done and put the cost of the engine complete for...
Forum: Swap Shop
02-25-2022, 09:00 AM
Replies: 24
Views: 8,666
Posted By MikeSXT25

Central Washington state. Engine has not been...

Central Washington state. Engine has not been rebuilt
Forum: Swap Shop
02-24-2022, 10:51 PM
Replies: 24
Views: 8,666
Posted By MikeSXT25

$5000 no exhaust

$5000 no exhaust
Forum: Swap Shop
02-24-2022, 01:33 PM
Replies: 24
Views: 8,666
Posted By MikeSXT25

496 Mag HO

Selling 496HO. Boat had 219 hrs when removed. Computer was stolen. Has been replaced with new Mercury computer. ($2200). Complete drop in engine with coupler and bell housing.with DANA...
Forum: Fountain
10-05-2021, 12:52 AM
Replies: 1
Views: 1,256
Posted By MikeSXT25

91’ Fever Parts locator

I am in need of some parts for my 91’. I need the drive indicator for dash( mine was missing at purchase). And bracket that holds the cable for drive and tabs dash indicator cables. Along with...
Forum: General Q & A
09-19-2021, 11:43 AM
Replies: 4
Views: 566
Posted By MikeSXT25

Ok that makes sense. But what about the other 2...

Ok that makes sense. But what about the other 2 wires. Purple with yellow and purple

...
Forum: General Q & A
09-18-2021, 10:19 PM
Replies: 4
Views: 566
Posted By MikeSXT25

HP 500 carb distributer wiring??

just picked up a fountain 27 with a hp 500 carburated motor. was poking around distributor timing it and noticed a few stray wires.
-one is a purple with white stripe female bullet connector with a...
Forum: Fountain
08-30-2021, 08:47 AM
Replies: 2
Views: 1,438
Posted By MikeSXT25

91’ Fever cup holders?

My wife’s only complaint about our new to us 91’ 27 Fever is there are 0 cup holders. Anyone have pics or ideas that aren’t the classic swinging cup holders ?
Forum: Wanted
08-23-2021, 12:23 PM
Replies: 0
Views: 171
Posted By MikeSXT25

ISO fountain 27 trailer

Need a decent trailer for my 27 fever. Came with a old junker roller trailer. Needs to have bunks and don’t want to convert this one.
Forum: Fountain
08-22-2021, 04:00 PM
Replies: 3
Views: 856
Posted By MikeSXT25

Best covers for Fever 27

Just purchased a 91’ 27 Fever. The cover it came with has just about had it. Where is best place to buy a new one that will fit snug and keep water and sun off ? Not wanting a one size fits most type
Forum: General Q & A
06-20-2021, 05:53 PM
Replies: 2
Views: 722
Posted By MikeSXT25

From what I see the drive snout. Is getting stuck...

From what I see the drive snout. Is getting stuck in aluminum at the 2-3 o clock position looking into fumble housing. Judging by scratch marks
Forum: General Q & A
06-20-2021, 02:38 PM
Replies: 2
Views: 722
Posted By MikeSXT25

Bravo 1 bellows retaining ring problems

I have been fighting my drive to get it off and found the aluminum retaining ring on bellows Hangs up on drive. Just enough to make it a real pain to get off. Can that be sanded/tuned up for...
Forum: General Q & A
05-04-2021, 11:43 AM
Replies: 34
Views: 5,241
Posted By MikeSXT25

This is a brand new housing so we all know. I’m...

This is a brand new housing so we all know. I’m goin go change thermostat out to be sure. But looking at it. With the correct cup for notched manifold in housing doesn’t seem like it protrudes below...
Showing results 1 to 25 of 59
 
Page 1 of 3
1
2
3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.