Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 3
1
2
3
Search: Posts Made By: bpine
Showing results 1 to 25 of 70
Search took 0.01 seconds.
Forum: General Q & A
10-29-2005, 09:24 PM
Replies: 1
Views: 685
Posted By bpine

#5 drive tools

Anyone have #5 drive service tools they want to part with?



Thanks Bryan
Forum: General Q & A
10-22-2004, 04:04 PM
Replies: 5
Views: 966
Posted By bpine

Re: fraudulent procharger ad

Smitty, Did ebay respond to you on any of your complaints?

thanks for the heads up!

Bryan
Forum: General Q & A
10-17-2004, 06:01 AM
Replies: 41
Views: 16,533
Posted By bpine

Re: Urgent! Engine stand ??

I will be in Macau China in two weeks for a race. I will make sure they hear what the power to be's at OSO think about their crap! Remember when we said that about Japan! DOHHHHHH! :eek:
Forum: General Q & A
10-17-2004, 05:54 AM
Replies: 41
Views: 16,533
Posted By bpine

Re: Urgent! Engine stand ??

Like I said, Toy, and how long did that run in a offshore boat! I could use that to start my TAD! :D :D Just kiddin! sounds like a cool motor!
Bryan
Forum: General Q & A
10-16-2004, 05:07 PM
Replies: 6
Views: 1,477
Posted By bpine

Re: 525 sc's

I Rebuilt my SC600 with the advise and help from BOB Teague! They built a set of heads and recommend a cam. I was very please with the results! Just make sure you talk to BOB! I also switched over to...
Forum: General Boating Discussion
10-15-2004, 04:04 AM
Replies: 2
Views: 510
Posted By bpine

Re: 36' Offshore Boat Need new exhaust maybe CMI

Do they make water jacketed Zoomies? :D :D

It also has a #9 drive and 14 hp per cylinder! :eek:
Forum: General Boating Discussion
10-15-2004, 01:54 AM
Replies: 2
Views: 510
Posted By bpine

36' Offshore Boat Need new exhaust maybe CMI

Just want your opinion on what exhaust and prop I should use on my new 36' Racer!

Bryan

http://www.offshoreonly.com/forums/attachment.php?attachmentid=101112&stc=1
...
Forum: General Boating Discussion
10-13-2004, 09:41 PM
Replies: 5
Views: 1,307
Posted By bpine

Re: What do you use to clean oil from the bildge?

First I through in a couple of those oil absorbent towels. cost about .75 each then dawn to get the rest!

Bryan
Forum: General Q & A
10-11-2004, 05:37 PM
Replies: 41
Views: 16,533
Posted By bpine

Re: Urgent! Engine stand ??

You have a real motor, get a real stand!

thats stand is made for those toy car motors!

Get the two legged version, you will be much happier!
Sell that one to some kid with a Toyota, tell him...
Forum: General Q & A
10-11-2004, 05:28 PM
Replies: 0
Views: 1,018
Posted By bpine

#5 drive prop shaft change and tools

The previous owner of the drive didn't take care of it very well! it keeps eating up seals and water enters the drive! The shaft is just to pitted to make a seal!

So I will change the shaft,

I...
Forum: General Q & A
10-10-2004, 05:59 PM
Replies: 4
Views: 755
Posted By bpine

Re: hyd steering question

I just completed this on my scarab this Week, The cost was $920.00 for the kit from Imco! I also put on a cordless trim steering wheel Total cost from that was around $700.00. It was real easy to...
Forum: General Boating Discussion
10-08-2004, 04:29 PM
Replies: 8
Views: 993
Posted By bpine

Re: Prop Puller for #5 Wanted

Thanks for the information Guys!

The Previous owner didn't take much care of the shaft!

I think he left the prop on for extended period after saltwater excursions!

I do use allot of marine...
Forum: General Boating Discussion
10-07-2004, 05:31 PM
Replies: 8
Views: 993
Posted By bpine

Lightbulb Prop Puller for #5 Wanted

I would like to Purchase a Prop Puller to assist me pulling off my prop without damaging it! Any suggestions or comments? I have searched the net and found lots of pullers for Ski and yacht's....
Forum: General Q & A
10-06-2004, 12:49 AM
Replies: 4
Views: 710
Posted By bpine

Re: boost & rpm

Cafe,

Just curious. What cabs are you running, Jets. Power valves, are they boost referenced?

Don't forget you will have to Re-jet and most likely prop change!

Thanks

Bryan
Forum: General Q & A
10-05-2004, 06:26 PM
Replies: 2
Views: 1,085
Posted By bpine

Re: OK to Boost?

The Marine Performance Chart from B&M says no! you are to close to the effective compression ratio of 10.75:1. I posted this chart in an earlier post!
...
Forum: General Q & A
10-05-2004, 06:15 PM
Replies: 4
Views: 710
Posted By bpine

Re: boost & rpm

Yes, you RPM's will rise! Its hard to say how much depending on several factors! Boat weight, FUEL, Prop,type of boat, ect! It wont be allot! On one of my Twin Turbo motors "Remember boost is boost"...
Forum: General Q & A
09-30-2004, 07:59 PM
Replies: 12
Views: 1,398
Posted By bpine

Re: timing "bounce" with v6 module?Normal?

Something doesn't sound right to me with 18 initial, that means you only have 10 degrees advance?

I have found the best performance with running 10-12 initial 600rpm or below and 30-32 total?All...
Forum: General Q & A
09-30-2004, 05:07 PM
Replies: 12
Views: 1,398
Posted By bpine

Re: timing "bounce" with v6 module?Normal?

I agree with Sutphen30, should be rock steady! thats not good at all for your motor! In this case I would have Just Replaced the whole Dist. with a pre set Advance unit from Performance Distributors!...
Forum: General Q & A
09-23-2004, 02:18 AM
Replies: 6
Views: 1,032
Posted By bpine

Re: Exhaust for a BBC????

Chris. Did you take a look at IMCO Powerflow! for your application I would think would be great. Imco is right there in your neck of the desert! Good people too.

Bryan
Forum: General Q & A
09-22-2004, 07:36 PM
Replies: 14
Views: 3,981
Posted By bpine

Re: Merc 600sc?Any Good?

I Just rebulilt mine after 8 years of faithfull service

26' Larry Smith Scarab SC 600 #5 Drive
Forum: General Boating Discussion
09-22-2004, 07:23 PM
Replies: 7
Views: 918
Posted By bpine

Re: #5 Drive Steering Assembly needed!

Thanks Ed, I decided to go full hydraulic steering! IMCO $920.00 I also replace my 10 Year old but still working GT Cordless Trim Steering wheel! FYI Gary Teague was a Very big Help at GT Marine!
...
Forum: General Boating Discussion
09-21-2004, 02:29 AM
Replies: 7
Views: 918
Posted By bpine

Re: #5 Drive Steering Assembly needed!

Thanks for the replies! I think I am going to take the full Hydraulic system! I hate that stupid cable! I just was not aware of the Hydraulic steering! Thanks again :D

Bryan
Forum: General Q & A
09-20-2004, 01:46 AM
Replies: 1
Views: 672
Posted By bpine

#5 Drive Steering assy. Needed

I am looking for a complete “NEW” Power steering cylinder kit for my 1992 #5 Drive! It connects to two external May Fair cylinders. My cylinders are fine! Just need the complete Assembly on the...
Forum: General Boating Discussion
09-20-2004, 01:42 AM
Replies: 7
Views: 918
Posted By bpine

Thumbs up #5 Drive Steering Assembly needed!

I am looking for a complete “NEW” Power steering cylinder Assembly for my 1992 #5 Drive! It connects to two external May Fair cylinders. My cylinders are fine! Just need the complete Assembly on the...
Forum: General Q & A
09-17-2004, 05:33 PM
Replies: 19
Views: 7,649
Posted By bpine

Re: Gm Zz 572

http://www.sallee-chevrolet.com/
Showing results 1 to 25 of 70
 
Page 1 of 3
1
2
3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.