Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: THE OUTLAW
Showing results 1 to 13 of 13
Search took 0.01 seconds.
Forum: General Q & A
04-23-2012, 01:48 PM
Replies: 2
Views: 615
Posted By THE OUTLAW

525 dist. Install

Anyone have a pdf or link i could use to get a pic of the proper placement of the reluctor wheel when installing the dist. in a 04 525? I printed it years ago and lost it. Thanks
Forum: General Q & A
09-26-2011, 10:30 AM
Replies: 8
Views: 748
Posted By THE OUTLAW

Yours seems to run 180-185 no? i think thats too...

Yours seems to run 180-185 no? i think thats too high...
Forum: Northeast US
08-26-2010, 10:05 AM
Replies: 372
Views: 33,165
Posted By THE OUTLAW

I think its 100.00 for boat and 4 people?

I think its 100.00 for boat and 4 people?
Forum: General Q & A
07-21-2010, 12:27 PM
Replies: 18
Views: 1,874
Posted By THE OUTLAW

Likely has CMI headers? They suck! You can have...

Likely has CMI headers? They suck! You can have them tested and welded if they are not too bad. I have them on my Donzi and have replaced 3 so far. Have a motor with only 160lbs comp. on the port...
Forum: General Q & A
06-14-2010, 01:34 PM
Replies: 0
Views: 643
Posted By THE OUTLAW

525 Timing Adjustment

I have a 04 525 and i had to put new lifters in it (one stuck down) i need to set the base timing. What do i have to jump,unplug ect.. and what should i set it at. Thanks!
Forum: Donzi
02-23-2010, 10:22 AM
Replies: 0
Views: 820
Posted By THE OUTLAW

Waste Tank Leak?

I have a 04 38 zx and the waste tank seems to be leaking. Do they have issues? Anyone know how to get it out? thanks.
Forum: Donzi
09-08-2009, 10:34 AM
Replies: 1
Views: 1,368
Posted By THE OUTLAW

Question Fuel Smell In Cabin When Filling Tank

Ijust bought a 04 38 zx W/ 525'S when i filled the tank (over filled came out the overflow) but still ran it for an hour or so after then docked it. I had a strong smell of gas in the cabin....
Forum: Drives and Lower Units
06-11-2008, 12:07 PM
Replies: 8
Views: 5,619
Posted By THE OUTLAW

Thanks Guys!

Thanks Guys!
Forum: Drives and Lower Units
06-10-2008, 10:38 AM
Replies: 8
Views: 5,619
Posted By THE OUTLAW

Oh..benperfected i just read your thread again.so...

Oh..benperfected i just read your thread again.so you go center of the prop shaft to the leading edge?
Forum: Drives and Lower Units
06-10-2008, 10:34 AM
Replies: 8
Views: 5,619
Posted By THE OUTLAW

Thanks for the input but i still dont know at...

Thanks for the input but i still dont know at what points on the drive to measure. front and rear
Forum: Drives and Lower Units
06-09-2008, 02:52 PM
Replies: 8
Views: 5,619
Posted By THE OUTLAW

Twin Bravo 1 Drive Alignment

I have a 2001 Baja outlaw 29,looking to adjust the tie bar between the two. Anyone know at what points in the drives front and rear that i can use to set it. I would imagine that there should be 0...
Forum: General Q & A
07-09-2007, 07:16 AM
Replies: 3
Views: 6,016
Posted By THE OUTLAW

Fireing order is good had replaced plugs,none...

Fireing order is good had replaced plugs,none fouled.Runs fairly well just after 1/2 throttle the rest of the throttle does nothing when you get to 4,000.Throttle plates are opening all the way.Any...
Forum: General Q & A
07-08-2007, 06:09 PM
Replies: 3
Views: 6,016
Posted By THE OUTLAW

Angry 454 Mag Mpi Will Not Rev Over 4,000 Rpm

I just bought the boat and took it out for the first time 2 weeks ago.both motors ran fine but the right motor the oil temp was higher than the other one.I removed the left manifold on the starbord...
Showing results 1 to 13 of 13


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.