Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: scarab300guy
Showing results 1 to 20 of 20
Search took 0.01 seconds.
Forum: General Q & A
10-24-2011, 12:17 PM
Replies: 14
Views: 6,396
Posted By scarab300guy

also, check the bearings both front and back. A...

also, check the bearings both front and back. A worn bearing could have the same effect. You can buy sealed bearings (whole set) new very reasonably on ebay.
Forum: General Q & A
10-24-2011, 12:11 PM
Replies: 14
Views: 6,396
Posted By scarab300guy

if the rotors are hitting each other it means...

if the rotors are hitting each other it means that one of the rotor gears is probably no longer torqued correctly, this allows back and forth play in the rotor and causes it to contact the other one....
Forum: Trucks, Trailers and Transportation
10-20-2011, 05:56 AM
Replies: 11
Views: 11,211
Posted By scarab300guy

08 F250, almost 50k, replaced sometime in the 20k...

08 F250, almost 50k, replaced sometime in the 20k range under warranty. Ford guy told me there was just a bad batch that went in the 08s. Replacement seems fine.

Some guys on here talk about...
Forum: Do It Yourself, Boating on a Budget
10-17-2011, 12:36 PM
Replies: 5
Views: 2,337
Posted By scarab300guy

Should be four wires coming off each alternator -...

Should be four wires coming off each alternator - 1) the ground wire (goes to block or - batt terminal; 2) Charge wire - thick and goes to the + batt terminal; and 3 and 4, which are the 2 thin wires...
Forum: General Q & A
09-28-2011, 09:36 AM
Replies: 14
Views: 2,767
Posted By scarab300guy

What brand and type of intake? Iron or aluminum?...

What brand and type of intake? Iron or aluminum? What intake gaskets were used? How were the front and back ends where the block meets the intake sealed (end pieces or just gasket sealer)? IMO...
Forum: Do It Yourself, Boating on a Budget
09-26-2011, 09:14 AM
Replies: 11
Views: 2,435
Posted By scarab300guy

Those aluminum gaskets you're referring to sound...

Those aluminum gaskets you're referring to sound like block-off plates. People use those sometimes when they can't keep the joint between the manifold and the riser from leaking back down into the...
Forum: Do It Yourself, Boating on a Budget
08-27-2011, 02:32 PM
Replies: 31
Views: 59,561
Posted By scarab300guy

what oil pressure are you getting with that motor...

what oil pressure are you getting with that motor (as in what is it at cold idle, what is it warmed up at 3k or 4k rpms, what is it at warm idle)? Should be 40 or so at cold idle, at least 10 psi...
Forum: Do It Yourself, Boating on a Budget
08-26-2011, 07:09 AM
Replies: 31
Views: 59,561
Posted By scarab300guy

No gears there, all hydraulic, drive won't go...

No gears there, all hydraulic, drive won't go down probably due to no fluid pressure coming from low pressure side of pump (high pressure side extends the rams, low pressure side retracts the rams). ...
Forum: Do It Yourself, Boating on a Budget
08-22-2011, 01:12 PM
Replies: 31
Views: 59,561
Posted By scarab300guy

No merctransii were ever put in staggered or on...

No merctransii were ever put in staggered or on 370's, he has the BW trans. The u-joint connects the drive to the tailstock on the BW trans. I would definitely inspect before considering removing...
Forum: Do It Yourself, Boating on a Budget
08-22-2011, 09:42 AM
Replies: 31
Views: 59,561
Posted By scarab300guy

is that a staggered scarab? i have pretty much...

is that a staggered scarab? i have pretty much the same boat. If its not banging in neutral its probably not the motor. Sounds like either a u-joint or if on fwd staggered (port) motor something...
Forum: Swap Shop
08-19-2011, 01:23 PM
Replies: 1
Views: 664
Posted By scarab300guy

Bumped

Bumped
Forum: Swap Shop
08-16-2011, 10:48 AM
Replies: 1
Views: 664
Posted By scarab300guy

Pair Solas Lexor 4 Blade 24p barely used (look like Bravo 1's)

Ran these for 2 hours on Scarab 377 staggered with new power @500hp per side, once all issues resolved came out slightly underpropped, went to 26p version of same prop. Not one scratch on them. ...
Forum: Swap Shop
08-15-2011, 12:46 PM
Replies: 8
Views: 828
Posted By scarab300guy

Atlanta GA

Atlanta GA
Forum: Wanted
08-12-2011, 06:38 PM
Replies: 3
Views: 543
Posted By scarab300guy

got a pair of 24p 4 blade solas lexor used 2...

got a pair of 24p 4 blade solas lexor used 2 hours - look just like bravo 1's and supposed to have less slip.
Forum: Swap Shop
08-12-2011, 09:57 AM
Replies: 8
Views: 828
Posted By scarab300guy

I have a new (used about 2 hrs) set of Solas...

I have a new (used about 2 hrs) set of Solas Lexor 4 blade 24's. Ran them on my 79 Scarab 377, worked great til I fixed a water leak, lightened up by about 1500 pounds and ended up under-propped,...
Forum: General Q & A
08-12-2011, 09:26 AM
Replies: 15
Views: 2,938
Posted By scarab300guy

I run Weiand 174s on BBCs with MSD Distributors...

I run Weiand 174s on BBCs with MSD Distributors (85551) and 6a boxes. Initials are 16 with 10 degree stop bushings made by a company in Idaho(?) specifically for miniblower apps. Total 26 using...
Forum: Scarab
08-10-2011, 12:28 PM
Replies: 4
Views: 1,177
Posted By scarab300guy

I have a 79 377 but it was mostly gutted long...

I have a 79 377 but it was mostly gutted long before I bought it. I believe the FW tank was forward of the helm stbd side and filled through one of the thru-hull fittings next to the gas cap. ...
Forum: Wanted
06-10-2011, 12:12 PM
Replies: 0
Views: 412
Posted By scarab300guy

Looking for a pair of 4 blade 24p or maybe 25p for Bravo/TRS

Cash or have several to trade including pair of Mirage 23p, 3 Mirage 25p (2LH 1RH) and a LH 22 Apollo 4 blade. The 23p are average, the rest are excellent.
Forum: Wanted
06-10-2011, 12:12 PM
Replies: 0
Views: 395
Posted By scarab300guy

Looking for a pair of 4 blade 24p or maybe 25p for Bravo/TRS

Cash or have several to trade including pair of Mirage 23p, 3 Mirage 25p (2LH 1RH) and a LH 22 Apollo 4 blade. The 23p are average, the rest are excellent.
Forum: Swap Shop
06-10-2011, 09:14 AM
Replies: 1
Views: 517
Posted By scarab300guy

Looking for a pair of 4 blade 24p for Bravo/TRS

Cash or have several to trade including pair of Mirage 23p, 3 Mirage 25p (2LH 1RH) and a LH 22 Apollo 4 blade. The 23p are average, the rest are excellent.
Showing results 1 to 20 of 20


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.