Offshoreonly.com - Search Results

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: cass236
Showing results 1 to 25 of 44
Search took 0.01 seconds.
Forum: General Q & A
09-03-2012, 11:39 AM
Replies: 7
Views: 758
Posted By cass236

Down on power, speed?

My rinker 236 used to consistently run 57-60 mph. 502 magnum carb. Best speed ive seen is 63.0. This year the boat will only do maybe 53mph. Same prop ive been running 23 plus mirage. used to see...
Forum: Baja
03-18-2011, 09:03 PM
Replies: 3
Views: 1,179
Posted By cass236

Just missed out on a great deal

For sale on Minneapolis craiglist: 2000 Baja outlaw 25 merc 500hp. 80hrs, SST package. $24,000! I called the day after it sold. If I only would have seen it a few days sooner. Congratulations to...
06-25-2010, 11:50 PM
Replies: 2
Views: 606
Posted By cass236

Trailer suggestions

I have a 95 heritage trailer. 6000lb cap tandem trailer. Seems like a lot of the wood may be rotting bolts on bunks are loose and rusted. Also it has surge brakes but im pretty sure they dont do...
06-25-2010, 11:42 PM
Replies: 3
Views: 657
Posted By cass236

Dodge 2500 gasser

I have a 3/4 dodge hemi 3.73 max tow is 8800
the same truck with 4.10 is rated 10500 i believe

So this tells me the limiting factor is the tranny. so if i pull 10000 with my 3.73 truck it may...
06-25-2010, 11:31 PM
Replies: 91
Views: 11,779
Posted By cass236

THIS I want to eat whale

THIS


I want to eat whale
Forum: General Q & A
06-25-2010, 11:09 PM
Replies: 17
Views: 1,894
Posted By cass236

Just thought i would update what the problem was....

Just thought i would update what the problem was. Shop said there was no spark?? I saw spark, but they replaced cap and rotors and a coil. Got it running said it wouldnt stay running because choke...
Forum: General Q & A
05-30-2010, 07:06 PM
Replies: 17
Views: 1,894
Posted By cass236

I almost had it going today, I primed it by...

I almost had it going today, I primed it by pouring some fuel directly into carb. I would open throttle and crank for about 5-10 seconds until it would start to fire and pop off a couple times but...
Forum: General Q & A
05-29-2010, 08:26 PM
Replies: 17
Views: 1,894
Posted By cass236

i put on a tester that plugs into the end of the...

i put on a tester that plugs into the end of the spark plug wire and then hooks to a ground. I saw spark while cranking the motor over.
Forum: General Q & A
05-29-2010, 05:07 PM
Replies: 17
Views: 1,894
Posted By cass236

I confirmed that i am getting spark, Must be...

I confirmed that i am getting spark, Must be fuel problem. I poured gas/starting fluid into carb and still wont start. I tried for about 45 minutes and got it to fire once for a bout a second or...
Forum: General Q & A
05-27-2010, 11:34 PM
Replies: 17
Views: 1,894
Posted By cass236

Help me start this 502!

Pulled my boat out of storage after winterizing. Got it started fairly easily and let motor run for a couple minutes. I noticed one of the muffs had cracked over the winter. I brought the boat in...
08-27-2009, 01:24 PM
Replies: 2
Views: 502
Posted By cass236

Help me decide on a new boat

After spending 4k on repairs on my 93. I decided i would be better off just getting a newer boat. Most of my boating is done on small local lakes (5k acres or less) There will be a occasional river...
Forum: General Q & A
07-11-2009, 11:19 AM
Replies: 10
Views: 1,284
Posted By cass236

Well im not going to spend 10k on a boat worth...

Well im not going to spend 10k on a boat worth about that, It would probably more economical to buy a newer boat. In the near future I'm going to get a faster hull anyway... I can get 67 on the...
Forum: General Q & A
07-11-2009, 08:57 AM
Replies: 10
Views: 1,284
Posted By cass236

Boat is 93 rinker 236. closed bow. 502 mag carb. ...

Boat is 93 rinker 236. closed bow. 502 mag carb. Prop is 23mirage plus. Last year it was spinning at 4700 rpm i could get 61 gps. This year it spins 5100rpm 61 gps??? Seems like a lot of prop slip...
Forum: General Q & A
07-10-2009, 07:31 PM
Replies: 10
Views: 1,284
Posted By cass236

How much should i pay for a engine rebuild? And...

How much should i pay for a engine rebuild? And in the process would it be best to keep it stock, how much more would it be to get it to 420-450hp. Can the bravo drive handle that power. From...
Forum: General Q & A
07-09-2009, 08:41 PM
Replies: 10
Views: 1,284
Posted By cass236

source of smoke?

My boat is 16 years old. When the engine runs it smokes just little bit. After i run the engine wide open and slow down to near idle speeds it smokes noticibly more for a few minutes. Is this a...
Forum: Baja
07-06-2009, 11:49 PM
Replies: 9
Views: 1,477
Posted By cass236

cheap fast baja

http://cgi.ebay.com/ebaymotors/1996-Baja-Bandit-25ft-H2X-Donzi-Scarab-Eliminator-FAST_W0QQitemZ190319208276QQcmdZViewItemQQptZPower_Motorboats?hash=item2c4fe8a754&_trksid=p4506.c0.m245&_trkparms=65%3A...
Forum: General Q & A
07-05-2009, 01:45 AM
Replies: 6
Views: 583
Posted By cass236

no prop is like new, on the engine cover it...

no prop is like new, on the engine cover it recommends 44-4800 rpm. This is the older carb 502 mag. not mpi.
Forum: General Q & A
07-04-2009, 11:43 PM
Replies: 6
Views: 583
Posted By cass236

Prop lost pitch?

After experimenting with several props i finally had found the right one. Mirage 23 plus. 4700 RPM, 61mph. Now is seems this year my wot is around 5100rpm. I seem to be 400 rpm higher or so at...
Forum: Prop Talk
08-26-2008, 06:53 PM
Replies: 7
Views: 8,629
Posted By cass236

update

I had already bought a mirage 23 p+, I also tried a 24p B1. the mirage23+ turned 4700rpm 60.7 mph. So i picked up 2mph getting it in the proper powerband. I tried the B1 top speed was 58.5 at...
Forum: General Q & A
08-24-2008, 12:07 AM
Replies: 5
Views: 4,069
Posted By cass236

Propshaft dyno?

I would like to dyno my boat to see if it is putting out its rated hp. Is there any places that this can be done w/o removing the engine in the upper midwest?
08-12-2008, 09:44 PM
Replies: 4
Views: 1,684
Posted By cass236

Overall it looks good, but the problem is in the...

Overall it looks good, but the problem is in the long triangle. It is noticeably worse each time i use the boat. I cannot say if it had the blisters or not before I took the boat home, but it didnt...
08-12-2008, 05:34 PM
Replies: 4
Views: 1,684
Posted By cass236

one month, the longest it has been in the water...

one month, the longest it has been in the water is 4 hours at one time. It seems strange the bottom wasnt painted, just the waterline on the sides. what can i do to fix it, does the whole boat need...
08-12-2008, 03:06 PM
Replies: 4
Views: 1,684
Posted By cass236

paint bubbling

I noticed on my boat i recently bought that the paint is bubbling and chipping away along the water line on the port and starboard side. There are little bubbles about 1mm in diameter. and you can...
Forum: Prop Talk
08-07-2008, 07:31 PM
Replies: 3
Views: 637
Posted By cass236

yeah, actually it is just the plastic one rated...

yeah, actually it is just the plastic one rated to 400. The metal one is for higher performance app.
Forum: Prop Talk
08-02-2008, 11:00 AM
Replies: 3
Views: 637
Posted By cass236

If you are talking about the torq flo those are...

If you are talking about the torq flo those are only rated to 400hp.
Showing results 1 to 25 of 44
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.