My new Tool (Not what you think)
05-18-2005 | 08:35 AM
#1
Thread Starter
Registered
Joined: Mar 2001
Posts: 1,454
Likes: 0
From: Mississippi
My new Tool (Not what you think)
Never again will have to lift a Drive.
I made this baby out of a motorcycle lift stand and some scrap metal laying around.
It only goes up and down but it works good.
I made this baby out of a motorcycle lift stand and some scrap metal laying around.
It only goes up and down but it works good.
05-18-2005 | 08:53 AM
#3
Thread Starter
Registered
Joined: Mar 2001
Posts: 1,454
Likes: 0
From: Mississippi
Re: My new Tool (Not what you think)
It realy works good for home made.
funny thing is that I have been tripping over the jack for 3 years and the other day I saw it and it hit me, kinda like Tim The Tool Man.
It will go high enough to reach that Hustler
the jack was a 100.00$
funny thing is that I have been tripping over the jack for 3 years and the other day I saw it and it hit me, kinda like Tim The Tool Man.
It will go high enough to reach that Hustler
the jack was a 100.00$
05-19-2005 | 12:36 AM
#7
Platinum Member
Joined: Jun 2001
Posts: 602
Likes: 0
From: Silverdale,Washington,USA
Re: My new Tool (Not what you think)
Great idea, if you made two of the legs (either the front or the back) adjustable(threaded rod inside a piece of tubing) then you would be able to adjust the angle from front to back.
Now I'm going to have to go buy one of those jacks to modify.
Thanks,
Caleb
Now I'm going to have to go buy one of those jacks to modify.
Thanks,
Caleb
