Fuel Pressure Gage
01-12-2006 | 02:12 PM
#2
Registered
Joined: Aug 2005
Posts: 1,491
Likes: 0
From: sint maarten
Re: Fuel Pressure Gage
assuming mpi like mine, the fuel rail has a test port in the front of it that you can tap larger and put your fitting into.
you want to be measuring right there at the rail... nowhere else...
and IF you are using a mechanical gage you want to run a -3 aeroquip line rather than the teflon... but i rec a 12 " long aeroquip line to an ELECTRIC sensor and then wires forward to the gage. you don't want the sensor screwed straight into the rail as this subjects it to all the vibrations and stresses on a threaded fitting... just asking to fail and light you on fire.
at the end of a short line ( or as long as you want) it isolates the sensor from all that and it last a LOT longer .. and maybe won't crispy critter you someday.
you want to be measuring right there at the rail... nowhere else...
and IF you are using a mechanical gage you want to run a -3 aeroquip line rather than the teflon... but i rec a 12 " long aeroquip line to an ELECTRIC sensor and then wires forward to the gage. you don't want the sensor screwed straight into the rail as this subjects it to all the vibrations and stresses on a threaded fitting... just asking to fail and light you on fire.
at the end of a short line ( or as long as you want) it isolates the sensor from all that and it last a LOT longer .. and maybe won't crispy critter you someday.
Last edited by stevesxm; 01-12-2006 at 03:12 PM.
01-12-2006 | 02:43 PM
#3
Thread Starter
Gold Member
Joined: Sep 2005
Posts: 1,987
Likes: 0
From: Missouri
Re: Fuel Pressure Gage
Originally Posted by stevesxm
assuming mpi like mine, the fuel rail has a test port in the front of it that you can tab larger and put your fitting into.
you want to be measuring right there at the rail... nowhere else...
and IF you are using a mechanical gage you want to run a -3 aeroquip line rather than the teflon... but i rec a 12 " long aeroquip line to an ELECTRIC sensor and then wires forward to the gage. you don't want the sensor screwed straight into the rail as this subjects it to all the vibrations and stresses on a threaded fitting... just asking to fail and light you on fire.
at the end of a short line ( or as long as you want) it isolates the sensor from all that and it last a LOT longer .. and maybe won't crispy critter you someday.
you want to be measuring right there at the rail... nowhere else...
and IF you are using a mechanical gage you want to run a -3 aeroquip line rather than the teflon... but i rec a 12 " long aeroquip line to an ELECTRIC sensor and then wires forward to the gage. you don't want the sensor screwed straight into the rail as this subjects it to all the vibrations and stresses on a threaded fitting... just asking to fail and light you on fire.
at the end of a short line ( or as long as you want) it isolates the sensor from all that and it last a LOT longer .. and maybe won't crispy critter you someday.
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
Zanie
General Q & A
5
03-10-2005 10:58 AM
