Buffing the "Ghost" out of the gel coat..
05-13-2006 | 09:52 AM
#1
Thread Starter
Registered
Joined: Sep 2005
Posts: 164
Likes: 0
Buffing the "Ghost" out of the gel coat..
Pulled the Scarab apart last night for the engine swap... man it was put together by wellcraft sloppy. There are parts of the boat that are still wet?!? The wood looks all good and solid... if I find anything soft I will replace.
Under the artificial lighting I can see now that the stickers on there are not the first and that they have been replaced. Can I buff the clear coat to get a nice shine and get the "Shadow" out from the old stickers?
Under the artificial lighting I can see now that the stickers on there are not the first and that they have been replaced. Can I buff the clear coat to get a nice shine and get the "Shadow" out from the old stickers?
05-20-2006 | 08:58 PM
#2
Registered
Joined: Apr 2006
Posts: 20
Likes: 0
From: LOTO, Missouri
Re: Buffing the "Ghost" out of the gel coat..
You should be able to buff out the where the old graphics were, if it don't work as well as you like you can always wet sand with 1200 grit up to 200 grit and then buff it out.
Thread
Thread Starter
Forum
Replies
Last Post
Ben@SRP
Trucks, Trailers and Transportation
14
10-13-2006 09:11 AM
Pure Energy
General Boating Discussion
9
02-21-2003 07:05 AM
mikesufka
General Boating Discussion
8
12-26-2002 11:23 AM
