Need a Gen 6 502 block
09-23-2007 | 10:14 AM
#1
Thread Starter
VIP Member
Joined: Apr 2001
Posts: 4,213
Likes: 0
From: Chicago il
Need a Gen 6 502 block
I need a gen 6 502 block. Any suggestions?? I would take a complete 502 Mag MPI motor or a 500 Hp EFI motor if the price was right.
__________________
Want your ECU tuned right?? Call Mark at Precision www.pmefi.com
Want your ECU tuned right?? Call Mark at Precision www.pmefi.com
09-23-2007 | 10:15 AM
#2
Registered
Joined: Jul 2004
Posts: 8,908
Likes: 9
From: Long Island,New York
09-23-2007 | 10:34 AM
#3
Thread Starter
VIP Member
Joined: Apr 2001
Posts: 4,213
Likes: 0
From: Chicago il
JC,
I can sleeve what I have, but I don't want to do that since I run a blower. I am already .030 over with a bore of 4.500. How much would it raise my comp. ratio if the block is milled .030 ??
Thanks,
Smitty
I can sleeve what I have, but I don't want to do that since I run a blower. I am already .030 over with a bore of 4.500. How much would it raise my comp. ratio if the block is milled .030 ??
Thanks,
Smitty
__________________
Want your ECU tuned right?? Call Mark at Precision www.pmefi.com
Want your ECU tuned right?? Call Mark at Precision www.pmefi.com
09-23-2007 | 10:39 AM
#4
Registered
Joined: Jul 2004
Posts: 8,908
Likes: 9
From: Long Island,New York
Thread
Thread Starter
Forum
Replies
Last Post
Rockfish71
General Q & A
4
05-29-2008 01:39 PM
