Need BRAVO 1 HELP ASAP!!
#1
Thread Starter
Registered
Joined: Mar 2007
Posts: 1,087
Likes: 0
From: Lake Dallas, TX
I took my boat out and docked it at the local marina, replaced my bunks and brought her back, when we pulled her out and reached the top of the ramp I hopped out to put on the tow straps and noticed that my drive was only halfway up. I tried unsuccessfully on several occasions both on land and putting her back in water, with the motor running, and not, the drive will only go half-way up and is just stops. The drive pump just quits like there is a kill switch, it works perfectly up to that point. I had to leave the boat at the dock parking lot, I cannot get it up the slightest hill and there are several.
1) Is there a way to release the drive and then lock-it in the up posistion?
2) WTF is going on?
thanx
1) Is there a way to release the drive and then lock-it in the up posistion?
2) WTF is going on?
thanx
#2
Banned
Joined: Oct 2006
Posts: 5,844
Likes: 0
From: Bradenton Florida
I took my boat out and docked it at the local marina, replaced my bunks and brought her back, when we pulled her out and reached the top of the ramp I hopped out to put on the tow straps and noticed that my drive was only halfway up. I tried unsuccessfully on several occasions both on land and putting her back in water, with the motor running, and not, the drive will only go half-way up and is just stops. The drive pump just quits like there is a kill switch, it works perfectly up to that point. I had to leave the boat at the dock parking lot, I cannot get it up the slightest hill and there are several.
1) Is there a way to release the drive and then lock-it in the up posistion?
2) WTF is going on?
thanx
1) Is there a way to release the drive and then lock-it in the up posistion?
2) WTF is going on?
thanx
It should be near the regular trim switch .

No worries nothing wrong with the drive .
#9
Thread Starter
Registered
Joined: Mar 2007
Posts: 1,087
Likes: 0
From: Lake Dallas, TX





