where is the best assortment of already prefabbed stainless reducers and misc. angles, couplers?
thanks,
john

try CP Performance, I've got some odd stuff from them before.
larry

Thanks,
John
I did check out there website but perhaps I may need to open there pdf catolog. I know I have seen these available somewhere. I just need to change the angle slightly before exiting the transom rather than spending a ton of money on sending my tails in to have then altered.

There are a bunch out there, but if i just need 1 or 2 pieces I use Mcmaster Carr. Go to www.Mcmaster.com & search for weld tube fittings.

Burns Stainless is also a good source.

If you can't find what you need at the places that Marc suggested, either I or CP Performance can build whatever you want. If you use CP, call CA. and ask for Mike Mays.
Eddie

never mind... everything you need is already there...