Buddy broke his outdrive
09-18-2015 | 09:55 PM
#1
Thread Starter
Registered
Joined: Aug 2015
Posts: 89
Likes: 5
Buddy broke his outdrive
Just a reminder, make sure both drives are lift at the same time. A friend of mine had loaded his boat and raised the drives but only one came up and snap. I guess the tie rod joints were stronger than the cast aluminum.[ATTACH=CONFIG]545355[/ATTACH]
Last edited by Tmaddox4x4; 09-18-2015 at 09:57 PM.
09-21-2015 | 10:16 AM
#4
Registered
Joined: Mar 2012
Posts: 1,230
Likes: 27
From: Clearwater, Mn
Tie bars have heim joints for a reason. there is more to the story, or his bar didn't have heim joints. I have personally seen may twin and triple set ups where 1 engine dies wile on the water. It is common practice to lift he dead engine's drive up and get back to dock/ shore on the other engine.....
