Doing a motor swap right now starting on mocking up a hardin sea strainer looking for options on where other people have installed them on their 25 outlaws .

Should I repost in do your self boating on a budget?

Not sure what the difference is, but my 24 outlaw is drivers side against the transom flush out runs around corner to side of engine compartment

Thanks this is the only spot I have found so far that I can put it . Didn't know if it would fit any where else with the motor out its hard to judge

My 272 is in the same place.

Guess it's a go thanks for the replies. Marked the transom lastnight gonna install tonight . Was thinking 3/4 inch long stainless lag bolts should be fine ?

Post some pics when your done

Can I post pics without paying?

yep create a photobucket album and post the image link

Anyone chime in on the size lag bolts I'm gonna use to mount 3/8 stainless 3/4 long?