What are you guys using ? is there a complete kit for a 4150 base

thanks

https://www.summitracing.com/parts/sum-g1419

I'm going with these

http://www.cpperformance.com/p-341-s...rburetors.aspx

They will also bend if needed depending on your set up.

Does it come with the cable holder and carb bushing ? Most don't for some dumb reason and prob why the OP posted this thread.

I went with what icu has and then a cable end kit from cp also. With the standard mercury controls the throw is off, on a set of controls with the different points to change the throw it's not a big deal

yes SB, is a complete kit to much to ask for............Indy where you able to get the adjustment correct with that bracket ??

I use this: http://www.cpperformance.com/p-14094...rsion-kit.aspx
that bolts to back of cable brackets. The brass barrel on the cable will slide on to this.

I get the bushing from where ever. https://www.summitracing.com/parts/mor-64920
Need to get a 1/4" bolt to gothru this and the cable end. I get 2 nuts for the bolt. That way, if you have to take cable end off this side, you can just undo one nut.

Thanks, that first link is much better than the single bolt clamp

I am adding he same piece from cp that SB posted. I swapped from fuel injection so needed it all