HP 500 hours
09-04-2018 | 07:00 AM
#1
Thread Starter
Registered
Joined: Nov 2013
Posts: 8
Likes: 0
From: Cortland NY
HP 500 hours
Hello, just wondering if there is anyway to tell how many hours are on a carb HP 500? Supposedly the key needed to be on for the radio to work, so it ran the hour meter up, but has since been re-wired. I don’t think there is anyway to tell being that it is not EFI but just wondered. Thanks a lot
09-04-2018 | 01:28 PM
#3
Registered
Joined: Nov 2004
Posts: 14,140
Likes: 3,706
From: On A Dirt Floor
09-04-2018 | 08:58 PM
#5
Banned
Joined: Jul 2011
Posts: 9,594
Likes: 46
From: Ft. Worth TX
with the Merc DDT and or Diacom with the correct adaptors all T bolt V ignition modules can be scanned for hours per rpm ranges.
Again if the engine has a MERC T bolt ign ./ module set up then you can scan for the hours per rpm ranges.
NO OTHER SCAN OPTIONS using a scan tool are offered with T bolt V only what I mentioned here..
Again if the engine has a MERC T bolt ign ./ module set up then you can scan for the hours per rpm ranges.
NO OTHER SCAN OPTIONS using a scan tool are offered with T bolt V only what I mentioned here..
Last edited by BUP; 09-04-2018 at 09:32 PM.
09-04-2018 | 09:08 PM
#6
Banned
Joined: Jul 2011
Posts: 9,594
Likes: 46
From: Ft. Worth TX
hour meter gauges some are installed not correctly - I seen them were the key position turned left ( counterclock wise ) for battery power to the stereo or whatever will also run the hour meter. Again depends on how it was wired -- by whomever.
with key on only ( one click to the right ) Not all warning horn outputs are a solid continues horn alarm when Key on only (test ) - it does vary between different apps thru the years, Just saying for one of the posts above..
with key on only ( one click to the right ) Not all warning horn outputs are a solid continues horn alarm when Key on only (test ) - it does vary between different apps thru the years, Just saying for one of the posts above..
Last edited by BUP; 09-04-2018 at 09:12 PM.
