Bravo sporadically getting after repairs...

Had gimble replaced at shop because I'm chasing a noise at idle. sometimes when pulling from F to N must pull twice. Also alignment was done. All was ok before repair and noticed once doing a on the water drive. It's going back to the shop but looking for ideas what happened. It's a good shop I have dealt with for years.

Thx

In English please???

English translation: Doesn't pull from forward to neutral at times after drive was off to replace gimbal bearing along with realignment.

Bent Shift Cable .....

Wonder if the top latch on the link bar is bound up so its not staying down, which would allow the cable to come loose

When going into forward is the cable pulled on at the drive, or pushed?

Right rotation