O ring size for block fitting for mercruiser fuel rail
12-17-2023 | 06:06 PM
#1
Thread Starter
Registered
Joined: Mar 2013
Posts: 27
Likes: 4
O ring size for block fitting for mercruiser fuel rail
I have a gen 6 454 mag mpi gen 3. There is a brass block with 2 o rings that go into the port side in the middle of the fuel rail. The schematic only shows 1 in the drawing and says 1 required. Any idea if they are the sane size? I'm assuming yes but my eyes start playing tricks on me. This is the part number listed 25-805970
12-18-2023 | 12:32 AM
#2
Charter Member # 55
Joined: Oct 2000
Posts: 20,232
Likes: 2,482
From: Omaha/LOTO
Guessing you have a VST system?? By the looks of the diagram, you would need one O ring for each hose that goes into the end of fuel rail
VAPOR SEPARATOR TANK AND FUEL RAIL (mercruiserparts.com)
VAPOR SEPARATOR TANK AND FUEL RAIL (mercruiserparts.com)
