Help Trs Outdrive
#1
I was running my boat this last weekend and slow down then got back on it and it felt like it was in neutral if i idle it it would move as soon as i gave it some throttle it would start slipping trans oil look good didn't hear any different sounds coming from it check linkage i am lost is it toast thanks
#4
What does it feel like if you turn the prop? Any crunchies? Drain a little oil out of the drive and see what it looks like.
__________________
Marc
www.mercruiserparts.com
www.go-fast.com
www.bammarine.com
www.cyborgtransmissions.com
It's not alive -www.BoatStuffExpress.com - temporarily retired
Marc
www.mercruiserparts.com
www.go-fast.com
www.bammarine.com
www.cyborgtransmissions.com
It's not alive -www.BoatStuffExpress.com - temporarily retired
#6
Registered
Joined: Apr 2002
Posts: 4,215
Likes: 0
not trying to insult you inteligence but is the trans oil level up to par?
Also does the engine rev way up when you apply throttle with it in gear, like it would if you where in neutral??

Also does the engine rev way up when you apply throttle with it in gear, like it would if you where in neutral??
Last edited by THRILLSEEKER; 05-19-2003 at 08:59 PM.
#10
Registered
Joined: Apr 2003
Posts: 43
Likes: 0
I had something similar happen to mine. There is a seal on the clutch pressure plate, which holds the oil in. This deteriated and popped out slighly jamming the pressure plate and destroying the seal. So no engagement of gear. I had a noise when this happened as is jammed still touching the clutch plates, and they slipped. Thought Id blown it.
Turned out it was a good job it did as some of the internal roller bearings used for reverse were seized, and one of them had its shaft spinning and wareing through its housing. This was a result of poor lube. From a holed cooling tube.
Now I am renewing shaft bearings and all seals on both boxes. + some of internal roller bearings.
Out of interest, what gear oil are you using.
Turned out it was a good job it did as some of the internal roller bearings used for reverse were seized, and one of them had its shaft spinning and wareing through its housing. This was a result of poor lube. From a holed cooling tube.
Now I am renewing shaft bearings and all seals on both boxes. + some of internal roller bearings.
Out of interest, what gear oil are you using.




