Offshoreonly.com

Offshoreonly.com (https://www.offshoreonly.com/forums/)
-   Skater (https://www.offshoreonly.com/forums/skater-42/)
-   -   Sweet 32' W/trips (https://www.offshoreonly.com/forums/skater/186801-sweet-32-w-trips.html)

Xchoke03 05-18-2008 12:01 PM

I am actually heading down the shore for another Run , I'll answer in more detail Tonight but the Cafe never saw 80. Top end was 75 to 78. It is a 10,000 lb boat.

TeamSaris 05-18-2008 02:50 PM


Originally Posted by Xchoke03 (Post 2561281)
I am in Marlboro NJ so we are not to far at all. For sure I'll spread the word about your 24. I actually took the wife and kids out today to the Barnegat Bay. We launched in Seaside and went North thru the Canal and out the Point Pleasant Inlet, Made a big U turn in the Ocean and head back. Nice 2 hours, water in bay was choppy as hell (very windy) but the boat was silk.

FF2 LG is about my favorite place on earth but Never been there in Summer. I always go up in the Winter and Sstay at the Riding High Ranch and Ski, snowmobile and all. Beautifull Place you have there. I'll come up in October for Sure !!!

Sounds Great!

28Skater300x 05-19-2008 08:05 AM

32 Skater
 
Congrats on your new boat.



Bill

activatorf1 05-19-2008 09:14 AM

May have a buyer for my 24 race boat !!! Next step , 300 Opti x 2

Xchoke03 05-19-2008 10:23 AM

Nice !!
 

Originally Posted by activatorf1 (Post 2562263)
May have a buyer for my 24 race boat !!! Next step , 300 Opti x 2

Good Luck !! I need a runnin partner. Especially one to show me around the Cheasapeak.

activatorf1 05-19-2008 10:25 AM

Ran the NJ shore for 20 years , went to Chesapeake one time , never went back to dirty, ugly , salt water again !! Going to call you in a little bit , going out on road .

Larry

dreamboater 05-19-2008 11:16 AM


Originally Posted by Beak Boater (Post 2559966)
Mark House had a 32 triple 300x boat here on the Potomac. From what he told me, the outside motors are behind the sponsons, somewhat protected, also helps to provide good water flow to the props to keep it from loading and unloading quite as much. The center motor runs in the tunnel, no protection and is subject to somwhat irratic water flow in rougher conditions.

That is Marks old boat in the pics. That boat never ran over 115 on our river.

Xchoke03 05-19-2008 01:26 PM


Originally Posted by dreamboater (Post 2562431)
That is Marks old boat in the pics. That boat never ran over 115 on our river.

What pics ? the ones i posted in the begining of the thread ? I only ask cause I have been told the boat has seen 122 on GPS by people who have no interest in the boat.

I would love to hear any and all info anyone is willing to share on 32' ers with triple set ups.

dreamboater 05-19-2008 01:37 PM

The 32 with the trip 300x's that Shogren had. The last owner lived in VA and boated on our river. I am not saying its not capable, but it never did it as far as I know. I am pretty sure it ran 114.7 or something in the radar run 2 years ago on our river. I raced him at least 10 times and he ran almost an identical speed to my 28 w/300 promax's. I am sure he was carrying a ton of fuel but just saying....I never saw the boat run the numbers that were mentioned. The center motor did give him some troubles...and I think the center lower about 2 or 3 times.

activatorf1 05-19-2008 03:44 PM

For the record , my 32 had a center engine water deflector in the mold . It was like a 3 ft ski ramp , I cut it off ,it looked like ****

Larry

skater 05-19-2008 04:41 PM

I was the one that owed this boat for over a year . The fastest I ever seen was 118.2 mph when low on fuel but keep in mind that was with the props I received with it when I purchased it. They were 3b 34's on the outside and a 3b 32 on the center and the props were in good but NOT perfect shape. With perfect thinned 3b 34's I believe 122 mph would be possible.

activatorf1 05-19-2008 05:52 PM

What year did you own my 32 ? I would be happy with 105 with a new pair of 300Opti's ! I have been running the new Hydromotive Ouad 4- X 28 on my IO race boat and night and day over any other prop I tested . What type of prop runs best for OB Skater ?? I would rather have a prop that works best in mid range with 5 people than a prop that only shines @ WOT

Larry

Xchoke03 05-19-2008 06:20 PM


Originally Posted by dreamboater (Post 2562603)
The 32 with the trip 300x's that Shogren had. The last owner lived in VA and boated on our river. I am not saying its not capable, but it never did it as far as I know. I am pretty sure it ran 114.7 or something in the radar run 2 years ago on our river. I raced him at least 10 times and he ran almost an identical speed to my 28 w/300 promax's. I am sure he was carrying a ton of fuel but just saying....I never saw the boat run the numbers that were mentioned. The center motor did give him some troubles...and I think the center lower about 2 or 3 times.

I am still unclear, are we speaking of the boat that is first pictured to start this thread ?

skater 05-19-2008 06:34 PM


Originally Posted by skater (Post 2562811)
I was the one that owed this boat for over a year . The fastest I ever seen was 118.2 mph when low on fuel but keep in mind that was with the props I received with it when I purchased it. They were 3b 34's on the outside and a 3b 32 on the center and the props were in good but NOT perfect shape. With perfect thinned 3b 34's I believe 122 mph would be possible.

Thats the one I was talking about .....

Xchoke03 05-19-2008 10:50 PM

Thanks Skater. When you owned the boat did you have much trouble with the center Engine ?
Any info you can give I greatly appreciate !

activatorf1 05-19-2008 11:53 PM

In no way shape or form do I think it would make sense for a third on our 32 , not worth extra fuel , weight , stress on transom and rigging for an extra 10 MPH !! I will be extremely happy if my hunk of **** runs 100 MPH with new 300 Opti's !

Larry

dreamboater 05-20-2008 06:47 AM


Originally Posted by Xchoke03 (Post 2562921)
I am still unclear, are we speaking of the boat that is first pictured to start this thread ?

Yes the one in the first pictures. That was Skater's old boat.

skater 05-20-2008 06:35 PM


Originally Posted by Xchoke03 (Post 2563326)
Thanks Skater. When you owned the boat did you have much trouble with the center Engine ?
Any info you can give I greatly appreciate !

I had a intermitent problem with the center motor that plagued me for over a month , the motor would only turn 5500 - 5800 rpms while the others would get on the limiters . Finally figured it out , it was the alternator and had it replaced . After that all was good. I did go through two lower units on the center motor in one season though : ( ...

TeamSaris 05-20-2008 07:18 PM


Originally Posted by activatorf1 (Post 2563372)
In no way shape or form do I think it would make sense for a third on our 32 , not worth extra fuel , weight , stress on transom and rigging for an extra 10 MPH !! I will be extremely happy if my hunk of **** runs 100 MPH with new 300 Opti's !

Larry

She ran 106 with 3 race 2.5s with 1990s technology so you may be close to the magic 100.:cool-smiley-011:

activatorf1 05-21-2008 08:12 AM

What is most inportant to me is that it stays together for 600 hours , no blower boat can do that

stainless 05-21-2008 08:42 AM


Originally Posted by activatorf1 (Post 2565040)
What is most inportant to me is that it stays together for 600 hours , no blower boat can do that

6oo hrs ?

activatorf1 05-21-2008 05:30 PM

What is most inportant to me is that it stays together for 600 hours , no blower boat can do that

activatorf1 05-21-2008 05:32 PM

The new Opti's

Xchoke03 05-21-2008 07:29 PM

Any luck on the sale of the 24 ? I got your message at the office but was running around a ton myself. I'll try to catch you tomorrow.

Patrick

activatorf1 05-21-2008 07:56 PM

I think it might be sold , my buddy who lives in Dallas Tx , near Lake Lewisville wants it . I sold him my spotless 21 ft outboard Checkmate .

Larry

TeamSaris 05-22-2008 06:19 AM

Larry,
are the motors going right on the transom or are you using some setback?
Johnny

activatorf1 05-22-2008 07:27 AM

I just filled the holes if you remember Skater ran Hyd hoses thru transom . Yes I will run CMC Stainless Jackplates . You said you ran jacks , but in thoses pics I can't tell .


Larry

TeamSaris 05-22-2008 02:16 PM

Manual jacks yes.

Xchoke03 05-22-2008 08:34 PM


Originally Posted by activatorf1 (Post 2565966)
I think it might be sold , my buddy who lives in Dallas Tx , near Lake Lewisville wants it . I sold him my spotless 21 ft outboard Checkmate .

Larry

Nice !!! Hopefully it works out. I'll be down the Jersey Shore this weekend ( I Know you prefer the Cheasapeak) but if your anywhere in the neighborhood shoot me a call on the Cell and we'll take a ride.

activatorf1 05-22-2008 08:47 PM

This weekend is Bad , but I will for sure take you up on that offer !!! How far are you from cherry hill NJ?

Larry

Xchoke03 05-22-2008 09:21 PM

I live in Marlboro (just North of Freehold by Colts Neck) so it can't be but 30 or 40 minutes.
I know I owe you transom pics, I haven't had a chance with the cruddy weather but I plan to wash/wax the boat tomorrow for the weekend and I'll snap off a few. Let me know if there is any real specific shots you want to see.

Patrick

activatorf1 05-22-2008 11:24 PM

I would love to see int shots , esp back seat . As far as Transom area goes , the Motor well, engine mounting area and cockpit floor . In the Cocpit I have a grid system because my boat was built as a race boat , now it is a pimp wagon , so I need to remove the trip Hazard


Larry

TeamSaris 05-27-2008 06:15 AM

Hey Larry, I talked to my dad who tells me the motors were bolted right on the transom. Sorry for the bad info.
Johnny

activatorf1 05-27-2008 07:42 AM

Thanks ! I kept looking at the pic and said where are they !

Larry

TeamSaris 06-04-2008 04:18 PM

Hows the project going Larry?
Johnny

activatorf1 06-04-2008 04:44 PM

I have been huffing dust 8 hrs a day on this thing , I removed the the center engine water deflector on top of tunnel , filled all transom holes and about to bond in an extra 1.5 of transom , made from 3 pcs of 5 ply 1/2 plywood lamanated together . After the inner transom is done I will make a fiberglass motor well to finish off the rear of boat because Skater never did .After that is done , I will paint it . Does anyone have the Center to Center engine spacing on a 32 Classic outboard ?


Larry

TeamSaris 06-05-2008 05:43 AM

Sounds Good. You will love this boat when its done.:cool:

activatorf1 06-05-2008 11:51 PM

I just hope that I get to drive it before my balls are dragging the ground or riding a Lark or Rascal !!!!!

TeamSaris 06-06-2008 05:25 AM


Originally Posted by activatorf1 (Post 2581626)
I just hope that I get to drive it before my balls are dragging the ground or riding a Lark or Rascal !!!!!

:drink::drink:

activatorf1 06-06-2008 10:19 AM

My Stainless CMC jackplates arrived today . 1600.00 for two


Larry


All times are GMT -5. The time now is 07:25 AM.


Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.