Xchoke03

I live in Marlboro (just North of Freehold by Colts Neck) so it can't be but 30 or 40 minutes.
I know I owe you transom pics, I haven't had a chance with the cruddy weather but I plan to wash/wax the boat tomorrow for the weekend and I'll snap off a few. Let me know if there is any real specific shots you want to see.

Patrick

activatorf1

I would love to see int shots , esp back seat . As far as Transom area goes , the Motor well, engine mounting area and cockpit floor . In the Cocpit I have a grid system because my boat was built as a race boat , now it is a pimp wagon , so I need to remove the trip Hazard


Larry

TeamSaris

Hey Larry, I talked to my dad who tells me the motors were bolted right on the transom. Sorry for the bad info.
Johnny

activatorf1

Thanks ! I kept looking at the pic and said where are they !

Larry

TeamSaris

Hows the project going Larry?
Johnny

activatorf1

I have been huffing dust 8 hrs a day on this thing , I removed the the center engine water deflector on top of tunnel , filled all transom holes and about to bond in an extra 1.5 of transom , made from 3 pcs of 5 ply 1/2 plywood lamanated together . After the inner transom is done I will make a fiberglass motor well to finish off the rear of boat because Skater never did .After that is done , I will paint it . Does anyone have the Center to Center engine spacing on a 32 Classic outboard ?


Larry

TeamSaris

Sounds Good. You will love this boat when its done.

activatorf1

I just hope that I get to drive it before my balls are dragging the ground or riding a Lark or Rascal !!!!!

TeamSaris

activatorf1

My Stainless CMC jackplates arrived today . 1600.00 for two


Larry