resto 36 skater
05-21-2008 | 10:32 AM
#12
Registered
Joined: Dec 2006
Posts: 495
Likes: 0
From: Tucson, AZ
I had the seats all recovered,original back seat and buckets.Mike would have no trouble building you something if you needed it.The side combing pads were traced out of king starboard and bolted on.
The seats wre embroidered with the skater logo as well.
The dash panels were made by a company in missouri,there is a place in florida but we thought the dash material was too thin.We made templates out of plywood (luan) and used a compass to align the guages and holes.
Orignally I wanted black carbon fiber dash with the new silver carbon faced guages by Livorsi,they were not available so I went with black carbon guages and silver dash instead.Im happy with it.Mikes number is 305-323-3697 If you need the dash done ,I can put you in touch with the co .
The seats wre embroidered with the skater logo as well.
The dash panels were made by a company in missouri,there is a place in florida but we thought the dash material was too thin.We made templates out of plywood (luan) and used a compass to align the guages and holes.
Orignally I wanted black carbon fiber dash with the new silver carbon faced guages by Livorsi,they were not available so I went with black carbon guages and silver dash instead.Im happy with it.Mikes number is 305-323-3697 If you need the dash done ,I can put you in touch with the co .
05-21-2008 | 10:34 AM
#13
Thread Starter
Registered
Joined: Feb 2003
Posts: 1,517
Likes: 0
From: bluffton sc
The guages antique,seats paint,trim ect all gone.Anyone got pictures of the carnuba boat?
05-21-2008 | 07:24 PM
#15
Thread Starter
Registered
Joined: Feb 2003
Posts: 1,517
Likes: 0
From: bluffton sc
05-24-2008 | 07:53 AM
#17
Thread Starter
Registered
Joined: Feb 2003
Posts: 1,517
Likes: 0
From: bluffton sc
thanks for the pics, looked for them on NJPBC but couldnt find them. Cut out the floors and re did the fuel tanks and coated the insides with Darakane. All good, should be sea trialed next week.
