dont bill me, youll have to get ahold of my mom for that, and whats with this grasshopper stuff??? can you fill me in on this Dave

lol . . . look it up. Wikipedia or something

Grasshopper ???? Is it a chick at the club ???

that chick is ridiculously hot . . . .saw her in some ebay ads for boats

Things that make you go mmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmm mmmmmmmmmmm






C'mon now rediculosley hot

good luck Thanks Dave just put # 2 mask on Today and sprayed Silver for the Diamond Plate Base

a few more


Thanks again to Glass Dave for all your help

SWEET! . . . . . any more pics of that chick in post #43?


just thought of something else. When you are done with the diamonds only pull off the #2 and #3 mask leaving the largest outer mask, that will allow you to double check the 1/4" edge/border highlights. If for some reason you want to change it i can cut a mask to block off just the main diamond plate part and you can correct it. I still have the cutfile with registration marks in place.


Man this is great . . . I'm just gonna phone in graphics from now on . . . this is way easier

Sounds good Dave , if i have to i'll probably just use some 1/4" tape if i have to because those areas i talked about werent all that huge. Ill just see in the end when i pull it, off. thanks for your help its moving along pretty smooooothly now .

P.S. stop calling me so much at the shop, my dad thinks im not gettin anything done and says i'm not moving fast enough ... grasshopper

lol