36 Skater Project
08-08-2015 | 08:42 AM
#1016
Platinum Member
Joined: Mar 2005
Posts: 1,044
Likes: 3
From: Bethel Island, CA
With enough boat life 2 part loaded and ready in the caulk guns I proceeded to apply liberal amounts of caulking to the mating areas of the transom, aluminum plate and jackplate mating surfaces
I was working by myself and had to work with a sense of urgency due to the cure times of the 2 part sealant. Eventually I got it done
I was working by myself and had to work with a sense of urgency due to the cure times of the 2 part sealant. Eventually I got it done
08-08-2015 | 11:21 AM
#1018
Registered
Joined: Jul 2008
Posts: 1,654
Likes: 29
Not this year. I have not had time this summer to dial it in. Too many commitments. I did see 97.5 with my bravo props with 4 on board and 3/8+ tanks. It's at Boat Customs for bottom blue printing final clearcoat and some additional hardware. I'll be at Camden with my wife this year I was hopeful the wives could meet.
08-08-2015 | 08:36 PM
#1019
Platinum Member
Joined: Dec 2007
Posts: 887
Likes: 18
From: OHIO
Not this year. I have not had time this summer to dial it in. Too many commitments. I did see 97.5 with my bravo props with 4 on board and 3/8+ tanks. It's at Boat Customs for bottom blue printing final clearcoat and some additional hardware. I'll be at Camden with my wife this year I was hopeful the wives could meet.
Are you going boatless this year or will your skater get finished in time to have it there to.just have fun driving around?
Last edited by davidmercury; 08-08-2015 at 08:42 PM.
