Well . . . . in case you wanna go racing and crane off the trailer you can do that now . . . . . and lower the center motors down about another half inch :D

And so you dont slip off the shiny trailer . . . . super coolio Skater non slip on the drive guard fresh off my cutter :cool:





worse part is it looks to nice to step on :D

36 skater project
 

Man, Dave! I like what you're doing! yeh the skater is going to be ready to crane into the water now. Anybody have a strap for sale?
Pretty and clever with the radius notch on the tunnel pods!:drink:
I've never seen that done with the non-skid before, that's supercool!:drink:

Shoes have to come off early

Dave those non slip stickers are bad-A! I love them.. I may be hitting you up for some of those...

Looks great ! Are you bolting jack plates to transom with some kind of stainless plate to keep jack plate edge from chaffing paint ?

Incredible job you guy's..... OUTSTANDING !!!!!!!:drink:

Thats actually the way they were originally mounted and these were pretty much what was on it except they were the stainless ones (weighed a ton). Are we missing something? What would chafe? Do you have an example pic of what you are referring to? Thanks


Lemmie know, right now i only have black though. I can get clear but the quantity i have to buy is kinda pricey. I can do pretty much any logo in it :cool:

Yes I will post pix later . 0.90 stanless plates that get sandwiched between jack plates and transom . Yes the stainless Jack plates are a bit heavier but they are the only plates rated for severe offshore use . In your case you will most likely be OK only because those 2.5 wegh I think 350 lbs . In my case I have 3 Litres that weigh 505 . I had same alum plates on a checkmate that started to fail @ slot area after a few years of use . Just trying to help . If you need plates I can hook you up with them

Larry

36 skater project
 

I think the plates used between the jackplates and transom are good insurance with offshore outboard applications.:ernaehrung004: