36 Skater Project
#302
list of things to complete:
dash wiring, find and buy and install new fuse blocks for 4 engines behind dash, hook up gps speedo kit
run control cables thru bulkheads and connect at both ends
finish connecting gas tank fill and vent hoses both sides, complete pickup fittings at top of tank
measure gas tank for correct depth and order senders and install
finish routing engine harness, power supply wiring, water pressure hose for guages, etc from back to front thru bulkheads and console, install and wire in fuel pressure sending units and hi pressure fuel pumps
re-install engine trim pumps and wiring, come up with a solution for controls at helm
wire and install 19 instrument panel toggle switches
finish out water feed hoses and fittings and hook up everything to water distributor block and then measure, purchase and connect to engine adapter plates with appropriate fittings and hoses
reassemble remaining two outboards, clamps, midsection cans, gearcases, hang on transom.
hook up power cables to 4 Optima batteries and hope that I don't see sparks anywhere in the boat
Install hyd steering cylinders, wing plates, center plates, tie bars, connect hoses to cylinders,
reconnect hyd steering hoses fore and aft
bleed steering system
install new cockpit carpet
install new upholstered side panels
install front and back seats
probably a long list of misc. items that I will remember later
drink some beer and gaze at it for a while
dash wiring, find and buy and install new fuse blocks for 4 engines behind dash, hook up gps speedo kit
run control cables thru bulkheads and connect at both ends
finish connecting gas tank fill and vent hoses both sides, complete pickup fittings at top of tank
measure gas tank for correct depth and order senders and install
finish routing engine harness, power supply wiring, water pressure hose for guages, etc from back to front thru bulkheads and console, install and wire in fuel pressure sending units and hi pressure fuel pumps
re-install engine trim pumps and wiring, come up with a solution for controls at helm
wire and install 19 instrument panel toggle switches
finish out water feed hoses and fittings and hook up everything to water distributor block and then measure, purchase and connect to engine adapter plates with appropriate fittings and hoses
reassemble remaining two outboards, clamps, midsection cans, gearcases, hang on transom.
hook up power cables to 4 Optima batteries and hope that I don't see sparks anywhere in the boat

Install hyd steering cylinders, wing plates, center plates, tie bars, connect hoses to cylinders,
reconnect hyd steering hoses fore and aft
bleed steering system
install new cockpit carpet
install new upholstered side panels
install front and back seats
probably a long list of misc. items that I will remember later
drink some beer and gaze at it for a while
Last edited by davidmercury; 10-01-2011 at 10:42 AM.



