This is just mock-up , soon all parts will be blasted , epoxy prime , straight up Black ureathane ( single stage for those not familar with paint ) but I also lay three coats of clear , this way the shine is a mile deep .

Larry

Larry, awesome!

Will you blast the aluminum parts till the aluminum shows? or will you blast the parts just enough to remove surface coat and oxidized surfaces for you to have a stable surface for the epoxy prime and urethane?

Larry,

To summarize, you will have/build the following:


* trim lines in rigging tube
* lower pans have been glassed together
* trim actuator cable in rigging tube
* aluminum limiter can be installed in ram
* kit that includes solid stainless upper pin as well as block off plates
* paint and clear kote the engine exterior



would luv to see these in future pics

Way too much work and it may never get done

Looks good Lar

Larry, any updates on this thread yet?

Selling it ! When are you going to buy a 32 ??

:eek::eek:

Is the 375 hp a dyno number ? looking good hf...

They are built by the best , Shaun Torrente ( Mercury F- 1 ) They are around 350 hp with stock Throttle body and 360 + with STR 4 inch TB