400hp Verados Latham Tie Bars
#11
Registered
I'm pretty sure it's a new build Don with the 400s' in mind. I think both the Skater and DW will rock. I live to run in the rough and slop. I don't personally care about top end, but aired out performance in the rough between 75 to 90 mph. Steve and Troy, as I'm sure I would, will be happy with their cats. You want to haul a$$ buy Sam/Helts 338!
I look forward to the dialing in/ setup on these two.
I look forward to the dialing in/ setup on these two.
#14
Platinum Member
Platinum Member
#6 under the skater classlfieds 2014 338 widebody
Last edited by davidmercury; 07-11-2015 at 09:10 PM.
#15
Registered
#16
Registered
#17
Registered
When I stand behind the boat it does not look and narrower to me of any significance. Maybe just a touch. Also the way the tie bar is you have to take off the steering tie bar and plates to change the oil.
Not sure when the boat will be done but they are thinking in about two weeks.
It is a 4 seater. I hope to be able to go for a ride with Troy when they test it.
Not sure when the boat will be done but they are thinking in about two weeks.
It is a 4 seater. I hope to be able to go for a ride with Troy when they test it.
#18
The guys there told me that the lower shroud has to come off and if it is one piece that pulls off to the rear the plate that attaches to the plate on the motors with the bolts has to be removed. The tie bar mounts to the outter plate. They cut the shroud just enough for the plate to come through. I will take another look at again next time I am over there to confrim for you guys. If so not to big a deal as it would come apart pretty easy.
#19
Registered