Whew! I finally finished my quest to become Minnesota noise legal today. I had to remove the mufflers again to fully bolt on the turn-downs as there was only a 1" flange. Just in case, I installed DMP internal flappers. Then, I replaced the 4" exhaust hoses for good measure. This custom Imco tie-bar was necessary to clear turn-downs. I also added a set of Hardin Marine drive showers. Stainless, anyone? :drink:

http://img.photobucket.com/albums/v2...onic/tail1.jpg

http://img.photobucket.com/albums/v2...onic/tail2.jpg

http://img.photobucket.com/albums/v2...onic/tail3.jpg

Wow it would have been eaiser to move where they like loud boats LOL

I agree. Someday, I hope to move to Florida. Around my waters, there are not many go-fast boats. So, you get picked on.

That just sucks , Boat looks great

I'm finally getting down to the easier items on the list. My side vents had really yellowed. I wanted to replace them with the stainless side vents I saw on the 31SS at the Miami Boat Show. Unfortunately, the cutout is smaller and they wouldn't work. So, I ordered 8 new plastic vents and painted them using an etching primer and white paint. Much more better!

http://img.photobucket.com/albums/v2...onic/vents.jpg

where did you guys get the new rub rail? from sonic?

Might add that to one of my Spring projects.

Yes, talk to Bruce at Sonic.

Like Plum said talk to Bruce and its $2.60 per foot...

ok, thanks, now give me the bad news on removal and re-install...what are the do's and dont's ;)

what did you end up doing with the ladder ? i think i might add one this year.