Cabin door lid support
#1
Registered
Thread Starter
Cabin door lid support
I'm not sure what its called, but does anyne know the manufacturer and part number for the black support arm that holds up the lid above the cabin door?
I think that the previous owner may have replaced mine with one that is slightly longer than it is supposed to be. It does not want to go all the way down and seems like it is too much stress on the hinge when I push it down flush.
I think that the previous owner may have replaced mine with one that is slightly longer than it is supposed to be. It does not want to go all the way down and seems like it is too much stress on the hinge when I push it down flush.
#3
Registered
Platinum Member
Join Date: Sep 2004
Location: Phoenix N.Y.
Posts: 512
Likes: 0
Received 0 Likes
on
0 Posts
I'm not sure what its called, but does anyne know the manufacturer and part number for the black support arm that holds up the lid above the cabin door?
I think that the previous owner may have replaced mine with one that is slightly longer than it is supposed to be. It does not want to go all the way down and seems like it is too much stress on the hinge when I push it down flush.
I think that the previous owner may have replaced mine with one that is slightly longer than it is supposed to be. It does not want to go all the way down and seems like it is too much stress on the hinge when I push it down flush.
Did I see you this weekend running by the Water Front
#4
Registered
Platinum Member
Join Date: Sep 2004
Location: Phoenix N.Y.
Posts: 512
Likes: 0
Received 0 Likes
on
0 Posts
http://www.spdhardware.com
This is the place that sells the one that came with my 03.
Part# was spd-gs-4900-20
The 20 is the rating in pounds.I bought a 20 and a 30.I did put the 30 on but it was way to much.The rod assembly comes with the socket ends.I had to use the ball that was mounted with the old unit.I did end up using the old socket only because it seemed like a better set up.The old sockets on what I had treaded right on the new rod..I think they were like 15 bucks each.
This is the place that sells the one that came with my 03.
Part# was spd-gs-4900-20
The 20 is the rating in pounds.I bought a 20 and a 30.I did put the 30 on but it was way to much.The rod assembly comes with the socket ends.I had to use the ball that was mounted with the old unit.I did end up using the old socket only because it seemed like a better set up.The old sockets on what I had treaded right on the new rod..I think they were like 15 bucks each.
#5
Registered
Thread Starter
Here's a pic of what's on there now. It stays up and seems newer, but won't close all the way flush.
#7
Registered
Platinum Member
Join Date: Sep 2004
Location: Phoenix N.Y.
Posts: 512
Likes: 0
Received 0 Likes
on
0 Posts
Ancient chinese secret.......Take the lower plate and ball assembly..unbolt it and flip it over...Looks to me it may be upside down...
#8
Registered
Platinum Member
Join Date: Sep 2004
Location: Phoenix N.Y.
Posts: 512
Likes: 0
Received 0 Likes
on
0 Posts
#9
Registered
Thread Starter