|
Originally Posted by johnnyboatman
(Post 2877793)
Jason Lets Get That Motion Together, It Will Be Snowing Be4 Long.
|
Originally Posted by OkieTunnel
(Post 2877955)
Check your PM for the low down on the Motion. I also blew an oil leak on the Warlock last time out. It is somewhere around the remote oil filter adapter where it plugs into the block on the port motor. That puts it in the back and to the outside and under the headers. i am going to pull the carb and some other things off this weekend to try to get to it. If the motor has to be pulled i may have to pull it over to leon.
|
Originally Posted by johnnyboatman
(Post 2877789)
Wheres Little Mineral Located?
|
Originally Posted by TxHawk
(Post 2878102)
A leak or a blown hose? Did it lose oil psi? Hope the engine doesnt have to come out. That is not allowed in May.
|
Originally Posted by OkieTunnel
(Post 2878546)
Slow leak. Oil pressure very slowly goes down over the course of a few minutes (5-6lbs in 10 minutes) Bilge fills up with a few quarts of oil. Only happens when engine turning.
|
Originally Posted by daredevil
(Post 2878549)
Front crank seal !!!!!!!!!!!!!!!!
|
Originally Posted by jeff1000man
(Post 2878564)
He said it's on the back. Sounds like a loose fitting. Get back there with some wrenches and some teflon tape. :coolcowboy:
Sorry did not read the hole story.:eek: |
Originally Posted by daredevil
(Post 2878620)
Oh,,ok,,,rear seal......LOL
Sorry did not read the hole story.:eek: |
Originally Posted by jeff1000man
(Post 2878636)
Get a job and get off here. :grinser010:
|
remote oil line?
|
| All times are GMT -5. The time now is 06:36 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.