Re: Superbabi !! Heres your pics of your Y2K
 

Gary !!!
How the hell did you get home soo quick !! Jesus, you must have been doin a hundred !!

Re: Superbabi !! Heres your pics of your Y2K
 

Ok Guys Superbabi Was On The Go Today Hard And Fast. Merc Rep. In Town New Custom Cut 5 Blade 27" At 82.7 Mph. Still Think In The Rough 2' Will Hit 84 Mph. Water Was Dead Calm. The Fx-10 Bottom Job Has This Bow "running High " No Bow Lift Problems.!!!!!! As Always Thanks For All Your Support Rick. Rick Will Keep Superboat Alive And Strong For Years To Come!!! Tim ( 5508 ) And Bo Monstaaa Thanks For Spending The Day With Us Prop After Prop Test Ride After Test Ride You Guys Are Superboat Friends . Jim H Always A Pleasure To See You. Thanks Jc In And Out Allday. You Should Think 4 Wheel Dr. Scott ( Merc. Racing ) Your Dedication To Your Craft Is Outstanding, Thank You !!!!!!

Re: Superbabi !! Heres your pics of your Y2K
 

So most importantly...Are you satisfied Gary at this point.

Re: Superbabi !! Heres your pics of your Y2K
 

How many people on the boat when testing gary?

Re: Superbabi !! Heres your pics of your Y2K
 

Gary Yes All Is Good. :d .........tom 2 Guys And 50 Gallons. So Numbers Will Get Better.

Re: Superbabi !! Heres your pics of your Y2K
 

So, it is safe to assume the 600 is making full power?
Gary, the special Merc. prop, is that staying on Babi?
If not, you may want to consider the Hydro P5X.
A fellow over on the Pantera Forum is raving about the performance on his 24' Pantera. If I had the $$, I'd have one on order.
Also, I believe this is the prop Jcap runs and Krak tested...
I'm glad to hear things are better in Superboat land! :drink:

Re: Superbabi !! Heres your pics of your Y2K
 

I figure slip is 8 %. 4800#s plus two guys and fuel = 5800#s. Gal of gas is 10#s right?

Re: Superbabi !! Heres your pics of your Y2K
 

Yes Pat That New Blade Got Her Down To 8% Slip..

Re: Superbabi !! Heres your pics of your Y2K
 

You use a 2"spacer or not?

Re: Superbabi !! Heres your pics of your Y2K
 

If the engine was spinning 5200rpm the slip would be 8-9%. Even at 5400rpm the slip #s would be great!
Was a drive spacer added? or is that 5 blade prop that much better than the Bravo 1?
Gas weighs about 6lbs per gallon...