Inferno- Notorious
09-14-2005 | 07:57 PM
#31
Thread Starter
Registered
Joined: Oct 2003
Posts: 599
Likes: 22
From: Norwalk, Connecticut
Re: Inferno- Notorious
Got to run the boat a few times, But Starboard motor oil pressure was jumpin" around on the last run. Checked oil & found WATER in it. Stelling's header had pin hole & loaded up 2 cyls.,[ 1 ]-4hr. motor now junk, Just ordered new exhust from Trick, Stelling's want's $13,800.00 each SIDE!! Even had them pressure tested, Go F'n figure!!! Gotta say Thank's to Fred Again at trick Marine & Stainless Marine!!!
09-15-2005 | 07:57 AM
#32
Registered
Joined: Feb 2001
Posts: 5,367
Likes: 2
From: Freehold, NJ. USA
Re: Inferno- Notorious
Freakin' Stellings are what did us in...trashed both motors in one race!!... 
Originally Posted by 818181
Got to run the boat a few times, But Starboard motor oil pressure was jumpin" around on the last run. Checked oil & found WATER in it. Stelling's header had pin hole & loaded up 2 cyls.,[ 1 ]-4hr. motor now junk, Just ordered new exhust from Trick, Stelling's want's $13,800.00 each SIDE!! Even had them pressure tested, Go F'n figure!!! Gotta say Thank's to Fred Again at trick Marine & Stainless Marine!!!
Re: Inferno- Notorious
09-15-2005 | 02:43 PM
#34
Registered
Joined: Feb 2001
Posts: 5,367
Likes: 2
From: Freehold, NJ. USA
Re: Inferno- Notorious
Stainless is the way to go...Best of Luck Dave!
Originally Posted by 818181
Hey Marty, Yea I'm done with Stelling's!! Just ordered all NEW Stainless Marine Exhaust for the staggered setup, Hope everthing is good with you! Dave
