$3K shipped for both sets

can you send me the specs along with any flow numbers you may have up to .650 or .700.
thanks,
john
[email protected]

can you send me the specs along with some pics. Are these marine heads that have the anodizing and for the gen 6 engines? [email protected]

how much?

I am still interested in these if they are available. I am waiting on a spec sheet from you. However more importantly I need to know if they will fit on Mark 1V?

Thanks,,
John

I do not have flow numbers. I bought these heads from another member on the board and never got around to using them. They have never been cut on. Are you looking for spring specs? The head specs are here.... http://www.edelbrock.com/automotive_...erf_rpm3.shtml

These head will fit MK IV blocks as well as Gen V and VI. Most aftermarket are designed that way.

look at post below with a link to pics. There are specs of the heads one post up. And yes they will work on a Gen VI and yes they are anodized

link to pics here


http://cid-b5e91a91d17714f9.skydrive...w%20album?uc=3

thanks for posting the specs and pics. i need to know what area the heads are in and also if your up for any offers or if your firm. i am in need of two sets of heads as my other heads i had planned on using were in need of to much port work to get the runner size to prefered volume. i need to make a decision tomorrow either on these or ordering darts.

Thanks in advance for your quick response.

John

Bought some others.
Thanks though,
John