For Sale complete alpha setup with 2 outdrives and 1 transom assembly complete
#1
Thread Starter
Registered
Joined: Jul 2009
Posts: 264
Likes: 0
I have a complete alpha setup from my 87 Baja Force 235
transom assembly is complete inner and outer setup,
with steering components
First outdrive is complete with driveshaft which has the following newly installed with 0 hours on them
new driveshaft yoke
2 new cross bearings
bearing retainer
yoke seal carrier
yoke nut
fresh mercruiser drive fluid
small repair that was professionally tig welded by a local marina, not on any fluid passages,
drive is 100% complete just pulled off the boat,
everything was replaced literally about 2 months ago, and this drive has zero hours on it
outdrive will need some paint on it
2nd outdrive is complete minus the driveshaft,
this was my spare unit, that I never ended up using has about 20 hours of use on it,
paint is in good shape,
nothing wrong with it at all
I had it saved for a spare, but ive decided to switch over to a Bravo setup
complete alpha transom assembly which has the following newly installed with 0 hours of use
gimbal bearing
u joint bellow
complete inner and outer transom with all sterring lines, trim tab sender and limiter,
water hoses
steering setup
could use a fresh coat of paint
Im switching over to a Bravo setup so I would like to sell this stuff off to help pay for the Bravo swap,
looking to get around $1350 for everything will seperate if needed
if anyone is interested please pm me or email me at
[email protected]
located in Seaford, NY (on Long Island south shore)
thanks
transom assembly is complete inner and outer setup,
with steering components
First outdrive is complete with driveshaft which has the following newly installed with 0 hours on them
new driveshaft yoke
2 new cross bearings
bearing retainer
yoke seal carrier
yoke nut
fresh mercruiser drive fluid
small repair that was professionally tig welded by a local marina, not on any fluid passages,
drive is 100% complete just pulled off the boat,
everything was replaced literally about 2 months ago, and this drive has zero hours on it
outdrive will need some paint on it
2nd outdrive is complete minus the driveshaft,
this was my spare unit, that I never ended up using has about 20 hours of use on it,
paint is in good shape,
nothing wrong with it at all
I had it saved for a spare, but ive decided to switch over to a Bravo setup
complete alpha transom assembly which has the following newly installed with 0 hours of use
gimbal bearing
u joint bellow
complete inner and outer transom with all sterring lines, trim tab sender and limiter,
water hoses
steering setup
could use a fresh coat of paint
Im switching over to a Bravo setup so I would like to sell this stuff off to help pay for the Bravo swap,
looking to get around $1350 for everything will seperate if needed
if anyone is interested please pm me or email me at
[email protected]
located in Seaford, NY (on Long Island south shore)
thanks
Last edited by cbellamore; 08-10-2009 at 10:12 AM.



